Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Tue Mar 06 09:42:15 EST 2007 | realchunks
Hi Mark, Solder paste will not flow on Ni like it appears on HASL. Where you print it is where it will reflow. Has been like that for years. As a CM you should re-engineer / recut your stencil to provide proper solder joints. I seriously doubt i
Electronics Forum | Wed Feb 02 13:05:51 EST 2005 | russ
Process flow 1.Remove part - It may be necessary to bake assembly prior to removing. 2.Remove remaining solder from part 3.Apply flux to part 4.Apply solder spheres to part 5.Reflow part You may want to bake component before re-installing 6.Apply
Electronics Forum | Tue Nov 02 17:52:17 EST 1999 | Dave F
Jim: Several points: 1 If you�re correct about corrosion of your component leads (which is entirely possible if the leads are steel, as you say), then the AIM 264-5 no-clean may not be aggressive enough to remove the corrosion you are seeing routin
Electronics Forum | Thu Mar 08 08:03:16 EST 2007 | ck_the_flip
ENig can vary in quality, but I've never seen an ENiG board that's been downright unsolderable. At a CM where I worked, I had to prove a QE wrong. He was flippin' out (*no offense*) about black pad, something commonly seen on ENig boards, so what I
Electronics Forum | Sat Jun 23 11:35:58 EDT 2007 | grantp
Hi, Yes, we just built a new plant, and used copper again. The stuff we cut out of the old building was copper, and it was fine without any issues. We lay it on an angle so condensation flows to an end, and can be periodically vented, and we take a
Electronics Forum | Tue May 09 09:10:30 EDT 2006 | Chunks
Grease filters work well. They're cheap, easy to clean and come in all sizes. Will not reduce your air flow by much either.
Electronics Forum | Wed Jul 27 10:07:16 EDT 2011 | swag
We bought air dispenser guns that fit the cartriges. I can't remember where we got them - sorry. We built little aluminum "holsters" for the sides of the machines to put the guns in. The guns are hooked up to air with low pressure regulators. Wor
Electronics Forum | Tue Dec 08 08:52:42 EST 2009 | cunningham
How do people prepare there solder paste for screen print? We currently remove them from the fridge and mix them in a 500g solder paste tub mixer to mix the flux and paste together we waste to much paste at the moment as we only use the tub for 1
Electronics Forum | Sun Apr 25 10:28:46 EDT 1999 | Joe Cameron
Hello all, Been doing some comparisons on joints made using the soldering iron versus reflowed solder paste (on a QFP package). The difference is quite significant: the joints made by the soldering iron are inconsistent and in many cases not filled
winsouce.jpg)
.gif)
