Electronics Forum | Thu Dec 14 04:42:11 EST 2017 | jineshjpr
Can anybody suggest how can I achieve good solderability in convectional reflow oven If I reduced Convection Air Speed 80%. The whole purpose is to reduce 0402 LED tilting in the convectional reflow and the PCB having QFN with 60 to 120 sec soak, 30
Electronics Forum | Wed Dec 20 07:16:16 EST 2017 | stephendo
I agree with Evtimov. What he didn't point out is that the surface tension of the solder would vastly overwhelm any force from air flow.
Electronics Forum | Thu Dec 14 05:07:55 EST 2017 | tsvetan
picture of the problem would help people to speculate what you do wrong
Electronics Forum | Thu Dec 14 15:05:17 EST 2017 | emeto
I am pretty sure, you are looking into the wrong spot. Your paste is too much, or your part has very inconsistent narrow leads(that includes wrong pad design as well.)
Electronics Forum | Wed Dec 02 09:28:24 EST 1998 | Dave F
| Hi, | I'm looking for a small batch convection oven that will replace the dryer section of a batch ultrasonic cleaning machine to dry off excessive water from washed PCB's, | any suggestions for particular suppliers, will be appreciated. | Jack |
Electronics Forum | Thu May 13 12:41:10 EDT 1999 | Eric
| | We are currently looking at purchasing some BGA rework equipment. Could someone give us the pro's and cons of IR heating (top/bottom)vs. hot air convection ? | | All other tips are also welcome. | | | | Thanks | | | Philip, | I have been doing
Electronics Forum | Wed May 19 10:48:40 EDT 1999 | Glenn Robertson
| | | We are currently looking at purchasing some BGA rework equipment. Could someone give us the pro's and cons of IR heating (top/bottom)vs. hot air convection ? | | | All other tips are also welcome. | | | | | | Thanks | | | | | Philip, | | I ha
Electronics Forum | Mon Dec 27 18:44:14 EST 2004 | Mark
I am testing some BGA's (PBGA 30mm x 30mm) to evaluate the maximum ramp rate we can achieve in our reflow oven. Temperature is being measured at the body(top) of the component / not leads. After several trials (with various oven settings), the high
Electronics Forum | Wed Sep 15 07:34:49 EDT 1999 | Edmund
Hi, Can someone pls suggest to me the best reflow temperature setting for a force air convection oven. The details is as follow. 1) Heller 1700s 2) 12 zone---6 top and 6 bot 3) Solder paste --- Qualitek 691 non clean 4) board size : 159mm X 159mm
Electronics Forum | Mon Jul 27 13:59:11 EDT 1998 | Robert Steltman
We are about to run our first BGA devices and would appreciate some confirmation on a few points. First some details: PCB & Device: ============= 1) 16 layer (4 power, 4 gnd, 8 signal) 2) gold on nickel finish 3) ceramic BGA with eutectic balls Refl
