Electronics Forum | Fri Apr 09 12:46:10 EDT 1999 | Bob Barr
I have been using an Air-Vac DRS-22 for almost two years with very good results. Once a profile is developed it is very repeatable. The DRS-22 is no longer available, however. It has been replaced by the DRS-24. Unfortunately, the DRS-24 has a lo
Electronics Forum | Thu Jan 06 17:50:08 EST 2000 | Jeff Ferry
Greg, Check out Circuit Technology Center in Haverhill MA. We have 3 Air Vac BGA Rework systems and 1 Nicolet X-ray system. We offer either\or BGA rework services and X-Ray services. You can get a little more info at http://www.circuitnet.com/cat
Electronics Forum | Fri Feb 04 11:26:58 EST 2000 | Lisa Anderson
We are currently using an Air-Vac DRS24 hot air BGA/SMD rework unit. Most of our nozzles are designed to channel the exhaust away from nearby components. This and a minimum keepout of .100" has prevented any issues with secondary reflow of those co
Electronics Forum | Fri Sep 07 16:37:47 EDT 2012 | burb1999
Ive used the Camalot long time ago to dispense paste on BGA pads after removal then reflow with a machine such as the AirVac. What is the best way to do BGA repair on pads? Ive read alot just reball the bga then put it back on? Todd
Electronics Forum | Mon Sep 18 17:55:55 EDT 2000 | Dave F
Reworking BGA with hot air systems (ie, AirVac, SRT) is fairly complicated and requires fairly rigorous process control. Please compare and contrast BGA rework using hot air and your laser based system.
Electronics Forum | Tue Jun 15 02:33:37 EDT 1999 | jeff ferry
| Anyone know a independent PCB inspection of BGA (X-Ray). We have several test boards that need BGA inspection. | One more source. Circuit Technology Center. Both X-ray services on Nicolet X-ray systemm and BGA rework on Air-Vac and OK Internation
Electronics Forum | Thu Jan 09 12:21:13 EST 2003 | Yannick
Hello, We are in the process to buy a nw rework station I would lke to have your comment on the following rework. Ir550 form Ersa BGA-3591 form Metcal DSR22 ou 24 from Air-vac Thank You
Electronics Forum | Thu Jan 20 15:11:26 EST 2000 | Russ
I tested out the OK unit and found it to be a "down and dirty" rework machine that will do BGAs if demeanding thermal requirements are not needed. My largest concern was the lack of bottom side preheat. I have recently purchased the Air-Vac DRS24 a
Electronics Forum | Wed Mar 08 11:59:10 EST 2006 | c_nguyen
Hi Folks, Does anyone know whether the following machine can do Lead-Free BGA rework? Also how much you would recommend to pay for this machine? Please advice! Your input is greatly appreciated. ================================================ Air-Va
Electronics Forum | Wed Mar 08 11:59:18 EST 2006 | c_nguyen
Hi Folks, Does anyone know whether the following machine can do Lead-Free BGA rework? Also how much you would recommend to pay for this machine? Please advice! Your input is greatly appreciated. ================================================ Air-Va