Electronics Forum | Wed Jan 27 13:36:51 EST 2016 | sarason
No, but it does evaporate slowly when left open. It is used in electronics cleaning because of it's solvent and evaporative qualities. You can look up references like the CRC handbook to compare these properties side by side to other alcohols that ca
Electronics Forum | Mon Nov 12 12:59:19 EST 2007 | ck_the_flip
Here are the scenarios: *No-Clean Flux & Foam Fluxer: alcohol is used as a thinner (for titration purposes) if your flux is alcohol-based *No-Clean Flux & Spray Fluxer: alchol is used only as a cleaning agent for your sprayhead.
Electronics Forum | Tue Aug 01 20:31:39 EDT 2006 | aespino
Does anybody knows if there is any reaction if I clean OA solder/flux residues using Isopropilic Alcohol? Is there any chemical recomended to clean residues manually instead of using a washing machine.
Electronics Forum | Tue Aug 01 22:04:11 EDT 2006 | davef
Problems with IPA are: * IPA / material being 'cleaned' combination still needs to be removed from the board. * IPA and empty containers are a hazardous material by RCRA criteria (40CFR 261) * Flash point (~12*C TCC) of IPA is low enough that all ele
Electronics Forum | Wed May 23 15:11:21 EDT 2018 | jacobidiego
Hi experts, I asked our chinese board manufacturer about their recommended procedure to clean miss-printing. The answer was that they use Absolut Alcohol while use IPA currently and we are moving to a water based cleaning agent with ultrasound. Th
Electronics Forum | Wed Aug 16 13:31:30 EDT 2006 | a_laser
You can stop cleaning after a job when there is no more paste in the apertures. Under wiping should be done with a quality cloth and should leave no paste on the underside of the stencil (assures good contact on the next print and reduces chances of
Electronics Forum | Fri Oct 21 14:13:08 EDT 2005 | mafc65
1.- Clean bottom and top stencil with a cloth/alcohol at same time.Pay special attention to fine pitch locations. 2.- Clean again bottom stencil side .To prevent any residual of solder 3.- Blow air with a air gun under the stencil to remove the solde
Electronics Forum | Tue Oct 11 10:49:14 EDT 2005 | jhagve
HI We start to make a product which have a 0.4 mm pitch IC and start having problems with not enough solder printed, to solve this problem we had to increase the manual cleaning, now we are cleaning the stencil every 8 printings, before we was runnin
Electronics Forum | Mon Jun 19 17:00:39 EDT 2006 | a_laser
The most common rates of in-process cleaning (under wipe) I have encountered are once per 5 to 10 prints. But this depends a on a lot of variables. More often is typically better, but more costly in under-wipe materials. (For some more info see http:
Electronics Forum | Fri Jun 01 20:30:27 EDT 2018 | jacobidiego
hahaha, I first thought the same joke and researched a bit. So to clarify to anyone reading this post, what the chinese guys called Absolut Alcohol is not the Vodka brand, it is Ethanol, which has
winsouce.jpg)
.gif)