Electronics Forum | Thu Dec 17 22:42:44 EST 2009 | voytek
Is it possible to run GSM without input/output conveyors? I would have to bypass SMEMA connection I think. All help appreciated.
Electronics Forum | Fri Dec 19 10:30:08 EST 2003 | haviland
Tony--Good morning. We deal in used and refurbed equipment and have a nice Panasonic line available now w/ DEK 265 printer, Pana PFA MV2CXL chip shooter w/ +(130) feeders, Pana MPA3F w/ +(60) feeders, BTU VIP 70 Reflow, several pieces of input and bu
Electronics Forum | Fri Feb 14 21:57:35 EST 2003 | caldon
Hello All- As per IPC SMEMA Specs the max gap distance should be .375" This standard can be downloaded from IPC's website at http://www.ipc.org/html/fsresources.htm This Doc has a fair amount of useful info. Best Regards, Cal
Electronics Forum | Tue Dec 15 12:23:47 EST 2009 | swag
I have moved golden boards from chains to mesh as I got tired of fishing t-couples under the chain rail. I saw a 3-5 deg. decrease on top-side parts peak temp. (all t-couples were on top side). I had to bump zones 6 and 7 a few degrees to make up f
Electronics Forum | Mon Mar 18 10:38:25 EDT 2013 | babe7362000
We are currently having an issue with one of our Jot Conveyors. The speed knob is on all the way (high setting), and the conveyor moves too slow and does not pass the sensor in time. Is there anything I can adjust to make the speed faster? Thanks
Electronics Forum | Fri Oct 14 09:58:13 EDT 2005 | patrickbruneel
Here's what I believe is happening. The main difference between the HASL boards and the gold plated boards is that HASL boards are pre-soldered. HASL boards need very little flux activity to get good hole fill and the machine settings have a wide pro
Electronics Forum | Wed Mar 14 08:45:41 EST 2001 | stefwitt
In order to track the board flow through your line you will have to hook up all conveyor input sensors as well as the last output sensor to a PLC. You can program the PLC to provide an alarm signal if a accumulative time of xxx hours for any board is
Electronics Forum | Tue Jul 18 10:16:49 EDT 2006 | russ
Clean up!, check all conveyors for paste, the printer, oven. If you are splattering in the oven than you need a better profile or better paste, one of the two, maybe both. Hope was helpful Russ
Electronics Forum | Tue Aug 20 10:07:44 EDT 2013 | mccabekev
I moved the fixed rail in by about 2 inches and it seems to have done the trick. Rail movement is easy, moving machine to keep all conveyors in line not so easy
Electronics Forum | Wed Jan 16 12:57:29 EST 2002 | Kevin Neal
Check all of the interlocks. The heaters and conveyor will not power up unless all of the interlocks are closed.
