Electronics Forum | Fri Feb 01 07:07:01 EST 2019 | dfl
Another semi-related question: are the four motion cards the same? (except for the dips, I guess). I have a spare one, marked as T motion, all dips to up position. Can I use as X or Y, if I match the dips? The boards look like to have the same comp
Electronics Forum | Fri Jul 27 11:22:26 EDT 2001 | cjrjmj
I would like to hear about equipment (all existing) that would do DIP insertion. We have UIC Multimods presently, but as you may or may not know spares and support are becoming an issue. All input is appreciated!
Electronics Forum | Tue Feb 15 06:30:23 EST 2005 | Hannu
Hello all Is somebody doing leadfree soldering with a dip soldering machine? What kind of alloy are you using? What temperature are you using? Any problems with wetting/soldering quality? Regards Hannu
Electronics Forum | Mon Jan 30 19:27:50 EST 2017 | jgo
Hi all, I'm wondering how does one decide to use flux dipping or solder printing when it comes to be attaching CSPs onto the board? Solder printing has an advantage in that there will be a higher throughput on the mounter as there is no flux dippin
Electronics Forum | Sun Nov 13 21:23:03 EST 2005 | jaciesla
Hello, I am looking to change from hand soldering to a dip soldering method. The board is double sided (only one side has components though) and has all through hole components currently. I would just like to know if dip soldering would be the best c
Electronics Forum | Wed May 09 13:11:22 EDT 2001 | zam_bri
Hi.. Recently, I have received a few reels of 0402 with an old date code ( but still less than 2 years old).I don't have a capability in-house to carry out the solderability test except for the dipping test ( dip the components in the molten solder
Electronics Forum | Wed Nov 16 09:22:24 EST 2005 | chunks
These are all good questions. Dip fluxing is fine. Make sure you let all the remaining flux drip off the board. Letting it drip into the pot will cause a lot of spattering of hot solder � be careful. Dipping the board slowly into the pot should
Electronics Forum | Thu Feb 25 13:28:02 EST 2016 | rgduval
I'm sure they'd be open to acrylic, as it'll provide a nicely hardened finish for them once cured. The real question is would it be workable to do what they're asking. That is, thick enough to coat the board when we dip it in without all slopping o
Electronics Forum | Mon Aug 07 20:43:42 EDT 2023 | smith88
I am looking for some tips of the trade with solder charges. I am using recommended reflow profile in the oven and I am seeing insufficient fill per IPC, and sometimes insufficient end joint. I have tried dipping them in flux also. What are you a
Electronics Forum | Thu Jan 19 10:53:43 EST 2006 | bobpan
Walter, Read what i posted above about switching the dip switch 8 on dip 1. That will probably solve your problem but once again....make sure you write down all your machine settings because everything will be reset.
winsouce.jpg)
