Electronics Forum | Thu Mar 13 09:23:26 EST 2003 | jrloudenjr
What types of systems/procedures are normally used or followed to allow for scrap percentages typically from a 43,000cph placement machine.
Electronics Forum | Fri Jun 26 19:02:09 EDT 1998 | Rin Or
I am very interesting of getting information about the criteria inspection of BGA. Example, what are percentage allowance for void, solder joint volume etc.. Any information feed back will be greatly appreciated.My factory just install the Nicolet NX
Electronics Forum | Thu Oct 26 17:42:29 EDT 2000 | Philip A. Reyes
Hi Mr Paul! Thanks for answering my previous questions. Hope you can still accommodate my other queries. This is about the acceptable criteria of PBGA defects after reflow soldering. 1.What is the allowable (min and max. ball misregistration / misal
Electronics Forum | Fri Jul 10 14:26:17 EDT 1998 | Bob Willis
There is a FREE yes Free inspection standard on my web site you can download. There is also information on my CD ROM, posters and video for BGA Inspection http://www.bobwillis.co.uk | | I am very interesting of getting information about the criteria
Electronics Forum | Tue Jul 07 03:34:06 EDT 1998 | Martin Kelly
Hi just to let you know, in case you don't, but an x-ray machine is needed too check the solder balls, once they've been placed. See you later, | | I am very interesting of getting information about the criteria inspection of BGA. Example, what are
Electronics Forum | Fri Mar 04 18:28:21 EST 2011 | hegemon
First, I would inspect for lack of solder bridges from the center slug to the outside leads. I would then look for evidence that the solder paste has reflowed beneath the component, without leaving too much void percentage. Typically we allow up
Electronics Forum | Mon Dec 06 00:22:41 EST 1999 | Greg H
Hi All, I have this problem sorting out the percentage of allowance that we need (per component) for our SMT machine attrition rate. When you say 1%. Say I have a PCB with 3 types of SMD components, type X is using 30 components, type Y is using 5
Electronics Forum | Thu Jun 01 21:54:00 EDT 2000 | Dave F
Jeremy: Standards: � A-600 talks about percentage of solder mask loss allowed, according to the location (eg, laminate, bare copper, gold or nickel, melting metals) and equipment class. � A-610 talks to "Solder Resist Coating - Voids & Blisters" by
Electronics Forum | Wed Apr 11 06:06:53 EDT 2001 | wbu
Hi Dreamsniper, the IPC land design standard is IMO a good reference. If you use the online calculator you can influence the result by varying for example manufactoring parameters. For the same lead width and same tolerances (and of course pitch) we
Electronics Forum | Thu Oct 26 16:38:08 EDT 2000 | Philip A. Reyes
Hi Sir Charles! Good Day! I hope you can help me about my queries. 1. What is the acceptable misregistration or misalignment of balls after reflow soldering of PBGA module on the PCB? 2. Is there any criteria for solder ball defect or solder beads
