Electronics Forum | Thu Jan 20 15:02:00 EST 2000 | Russ
Many times the crystal supplier also has a package that already has epoxy bumps on them to allow th crystal to be raised off of the board. This is my preffered way since placing spacers on components can be time consuming and operators can and will
Electronics Forum | Fri Jan 14 09:36:49 EST 2000 | Richard
If the gold fingers are pad types which plug into expansion slot connectors, I have used a titanium guard attached to the wave conveyor over the solder pot, which allows the PCB to connect to the fingers but masks the solder from the gold pads along
Electronics Forum | Wed Sep 29 17:30:15 EDT 1999 | Earl Moon
Thanks for everything, especially the recent responses to this corner and those of the editor. Please allow me the same privelege and to go in silence. Earl Moon (MoonMan)
Electronics Forum | Fri Aug 13 05:38:45 EDT 1999 | stefano bolleri
Ray, what about allowing everybody else to know about the "more info" ???? This is supposed to be a forum, isn't it? Bye, SB | Thanks for the reply, | i have sent you an e mail with more info in it. | thanks ray hare
Electronics Forum | Fri Jul 30 20:27:49 EDT 1999 | Dior
Has anyone done the research on BGA pad size? suppose I have a 0.030" diameter pad as recommended pad size from the spec, what will the minimum pad size allowed? We are laying out a high density board.
Electronics Forum | Sat Jul 31 13:27:42 EDT 1999 | Miguel Mariscal
| Has anyone done the research on BGA pad size? suppose I have a 0.030" diameter pad as recommended pad size from the spec, what will the minimum pad size allowed? We are laying out a high density board. |
Electronics Forum | Bob |
Wed Apr 07 19:40:07 EDT 1999
Electronics Forum | Thu Oct 01 12:02:04 EDT 1998 | Clifford Peaslee @ SMTnet
I fixed a problem today that would not allow people to post messages to a thread that was not in the current month. I hope this didn't aggravate people too much. If anyone finds any problems, please email me, so that I can act on it as soon as possi
Electronics Forum | Thu Oct 01 11:48:17 EDT 1998 | Clifford Peaslee
There was a small problem when the month has changed, which would not allow you to reply to an older thread. I have fixed that problem. Thanks for your patience. Cliff
Electronics Forum | Thu Jul 09 07:44:48 EDT 1998 | Jim Zanolli
Teka Interconnection Systems offers connectors with solder and flux deposited on each lead allowing for reflow without adding solder paste. www.tekais.com 401-785-4110 fax: 401-781-5730