Electronics Forum | Wed Feb 18 03:11:23 EST 2004 | Sam
Should I have any concerns with operators using flux for handsoldering, straight out of a 25 ltr drum which is not even thinned dowm to the correct SG level. The flux is Alpha 615-25 RMA based and we use it in our wavesoldering process. Thanks in ad
Electronics Forum | Wed Sep 15 05:15:24 EDT 2004 | Adam
I have chceked the fluxing application, I seem to be getting good consistent coverage across the board using our foam fluxing system. Good flux penetration on the top-side of the through-hole plating, as this was checked using a fax paper.There is no
Electronics Forum | Mon Jul 16 21:29:03 EDT 2001 | davef
Cleaning RMA with water is bad news. It will turn your solder connections white and remove none of the RMA residues. There was a thread on removing RMA within the past two weeks on SMTnet. Check the fine SMTnet Archives. Additionally, look at M
Electronics Forum | Thu Jul 22 16:36:06 EDT 1999 | Mike Konrad
Scott is right, Alpha' 2110 is a good saponifier (be careful though as it can dull your leads). Saponifiers in general are better if used in an aggressive spray-in-air system. Low agitation immersion systems (heated baths or refurbished vapor degre
| 1 |
