Electronics Forum | Tue Apr 13 13:22:15 EDT 2004 | babe
Try another solder paste manufacturer. Aim out of Rhode Island, Alpha and or Kester. I'm sure that they will be of better assistance than the current supplier. Good Luck
Electronics Forum | Sun Feb 27 13:42:44 EST 2005 | pmdeuel
So true, We had paste flux supplied to us from Alpha metals. It was the same as used in the solder paste. The major problem we noted was the in ability to control the ratio of paste to flux resulting in lots of voids. When we mixed enough to get the
Electronics Forum | Wed Apr 14 05:44:36 EDT 2004 | hun
Hi All, Just have a share with you guy. We are using T4 solder paste and also E-Stencil. We ahd try out Alpha, Kester, AIM and Qualitek. The result show Alpha had a very very heavy stack flux and can't get it clean off even by chemical
Electronics Forum | Thu Mar 06 17:02:40 EST 2003 | Kris
Try alpha fry technologies. http://www.frymetals.com/manufacturing/solder_reclain1.html
Electronics Forum | Tue Apr 13 14:56:51 EDT 2004 | russ
in a thread titled ".5mm bga" there is a reference to a paste by alpha that is no-clean and is supposed to be made specifically for this situation. I suppose that increasing the pad dimension to .012" is out of the question? Russ
Electronics Forum | Tue Apr 13 13:55:46 EDT 2004 | arcandspark
I have samples coming in, AIM and ALPHA, Multicore use to have manufacturing in the same town but disappeared. Your right about getting better help fro other, Indium is the worse I have ever had to deal with. They act like I am bothering them when I
Electronics Forum | Tue Apr 13 14:14:59 EDT 2004 | russ
I have actually printed this same condition with type 3 paste Alpha WS709. I posted this for discussion and cannot remember what I called it. We did need to clean the stencil after every three prints. I did not check volume on these locations but
Electronics Forum | Thu Feb 12 14:43:25 EST 2015 | emeto
Just my opinion: Stencil printers: 1. DEK 2. MPM 3. ..... Solder paste: 1. AIM 2. Alpha 3. Indium .....Kester
Electronics Forum | Thu Dec 10 09:06:47 EST 2009 | stepheniii
Just how cold do you store your paste? And what are your solder paste reps like? Here they fall over each other giving support for their paste. And have you seen the problem with flux separation or have you only heard about it?
Electronics Forum | Tue Dec 08 08:52:42 EST 2009 | cunningham
How do people prepare there solder paste for screen print? We currently remove them from the fridge and mix them in a 500g solder paste tub mixer to mix the flux and paste together we waste to much paste at the moment as we only use the tub for 1
