Electronics Forum | Thu Oct 18 15:33:03 EDT 2012 | jackofallmasterofnone
2) The conveyors do not show any signs of life when powered on. No lights, no sounds, no movement. 5) The router tracks the boards movement through the facility, and it also directs the employee to the tools and work instructions required for each
Electronics Forum | Tue Oct 16 14:18:41 EDT 2012 | ericrr
My guess is a manual machine would be good for a after sales "repair station" or the engineers doing product development, without it you would have almost drop a large integrated circuit (IC) on to the spot and poke around with it moving it sideways
Electronics Forum | Sun Nov 18 11:21:09 EST 2012 | kahrpr
Cost to mark them. Some of the cap manufactures do not have the equipment to do it. They have older lines and to retrofit them is cost prohibitive. A lot of OEMs do not want the values of everything on the boards so they are harder to reverse enginee
Electronics Forum | Sat Dec 08 00:09:24 EST 2012 | jlawson
Mentor(Valor) has dfm softwares that not only looks at the stecnicl layers buy can look at other impacts that could effect the optimisation of the stencil design, ie solder mask layer tolerances defined from fabricator-design etc - this is a upper en
Electronics Forum | Tue Dec 11 14:25:46 EST 2012 | juggalo
Ha ha, very funny. I also have tattoos, I use curse words, and I am young. I shouldn't be trusted with anything, yeah right. I hope that was actually meant to be a joke and I see the irony, but not every Juggalo is the same. Long story short and to
Electronics Forum | Fri Jan 18 12:34:14 EST 2013 | duchoang
Yes, I have. think I have pretty good reflow profile. We use Lead-Free,No-Clean,SAC305 Solder Paste. The problem is at LGA design.The pad size is alot bigger than BGA. They are totally flat and do not have balls/spheres which melted and collapsed thr
Electronics Forum | Wed Jan 30 17:23:07 EST 2013 | dyoungquist
In response to hegemon... This is not a recommended practice but..... We have added a few drops of water soluble flux to our water soluble solder paste when the paste is on the stencil. This was after the paste had "dried" out a bit. We have had
Electronics Forum | Wed Jan 30 16:36:24 EST 2013 | gmcvay6929
Reese, We had that problem a few years back. Simplimatic would not send us any information to fix it. We had to send the controller back to Simplimatic and have them fix the software in the controller. I noticed your chiefs logo on your name. I
Electronics Forum | Wed Feb 20 13:49:54 EST 2013 | tkotwal
I'm looking for a preheater for hand soldering, but haven't used one before so I could use some advice. Does anyone have any preferred styles or brands? Is there anything in particular that I should either look for or should avoid? I've seen prices r
Electronics Forum | Fri Feb 22 09:41:54 EST 2013 | patrickbruneel
Pete, It would even be better if the wave machine manufacturers would add a feature that allows the wave to drop in rpm when a board passed the wave, and slowly get the wave back to normal rpm when a new board approaches. This would be like a reset