Electronics Forum | Thu Aug 27 11:18:05 EDT 2015 | dyoungquist
From your description I am assuming you are doing double sided reflow and parts are dropping off the bottom side when the board is run through the reflow oven the second time. A few ideas to try: 1) Are the parts that are dropping off heavier parts
Electronics Forum | Mon Sep 14 23:21:06 EDT 2015 | solderotter
Hi there. We’re Solder Otter, a team of recent engineering graduates from the University of Waterloo in Canada that is redesigning the soldering iron so soldering electronics can be safer and simpler. You may have seen the survey we posted back in 2
Electronics Forum | Sat Sep 26 03:21:58 EDT 2015 | aemery
Mervin, Love these machines, Speedline built about 3500 of them so I have lots to fix. Most issues come down to incorrect use or poor adjustment and alignment. Your description is a little vague, you didn't mention which direction the prints are of
Electronics Forum | Fri Nov 20 03:47:22 EST 2015 | spoiltforchoice
When detected, a PCB with an FTDI FT232 IC will install drivers on the host PC and it will appear as a standard serial port. You can transfer data over it in the same way you would any other serial port,you can also inerface with it using FTDI's own
Electronics Forum | Tue Dec 08 22:39:05 EST 2015 | andrei8686
Hi anyone have recommended pcb manufacturer? My > require: quick delivery time; best > quality; affordable price; best service; PCB > Assembly provided > Hi anyone have recommended pcb manufacturer? My > require: quick delivery time; best > qu
Electronics Forum | Fri Jan 22 11:04:38 EST 2016 | stevea
The answer is CyberOptics. Buy Viscom SPI and you are already buying "CyberOptics Inside". Koh Young is far too expensive these days for comparable systems and Parmi is still an "Up and Comer" with a short track history leaving most of the long ter
Electronics Forum | Wed Feb 03 11:31:20 EST 2016 | steprog
Hi, New to this forum. I am an engineer assigned to resolve a quality issue on our production line. It seems that we have been getting small droplets of flux on our boards after the reflow process. Occasionally, they land on a board to board conne
Electronics Forum | Thu May 05 01:50:44 EDT 2016 | darby
Dear Forumites, It's been a while, but I have a question. I was recently asked to provide a scenario on capacity if we retired two older lines and replaced with a new line. My capacity figures were based on real time production over a period of six
Electronics Forum | Wed Jun 01 19:31:03 EDT 2016 | marcelll
Strange problem with a Versaflo selective wave Very long for the pot to reach is set temperature ( 5 h ) At 180 C, the pump doesn’t seem to start like it should be So very long to heat the bottom of the pot Finally, the bottom element is turning on
Electronics Forum | Mon Sep 12 09:26:00 EDT 2016 | awhite
Our MPM Up2000 HIE is having a communication problem with any upstream machine we place in front of it...i.e. conveyor, board loader, etc. It all started when we removed a conveyor from inbetween it and a board loader, and hooked those machines up di