Electronics Forum | Thu Jul 07 23:43:31 EDT 2022 | tey422
We been using the Sayaka SAM-CT23Q machine to depanel PCB, it was fine. But now, we have to depanel the Aluminum PCBs the current bits from IMPEC we are using are not strong enough (1.5x8.0 diamond downcut). Need to find much strong bit or bits des
Electronics Forum | Wed Jul 13 17:21:41 EDT 2022 | tey422
I just send a TQ email to Kemmer to find out more about it. Thanks so much for your help!
Electronics Forum | Sat Jul 23 12:41:26 EDT 2022 | madisreivik
If you need to cut longer lengths and chip clogging / evacuation / edge finish is problem, then contact me privately, we have an unique solution for that.
Electronics Forum | Wed Jul 27 17:26:55 EDT 2022 | proceng1
I'm having trouble picturing your setup, but can you put kapton on the columns? Or heat shrink tubing?
Electronics Forum | Mon Jul 11 18:02:27 EDT 2022 | tey422
Yes, just tabs not full perimeter. Can you please fill me in more detail since I am not too familiar to router bit types? I am looking for the right size bit that would be able to install to the Sayaka machine without much trouble just like diamond
Electronics Forum | Sat Jul 23 01:51:04 EDT 2022 | poly
You'll find a lot of guides for cutting aluminium on the internet but basically, try and use a bigger end mill if you can, keep it at the right speed (not slower). We cut 1.6mm aluminium with a 3mm end mill. Smaller end mills didn't evacuate the chip
Electronics Forum | Wed Jul 27 05:31:09 EDT 2022 | lindsaylbb
Aluminum shreds were found inside the tooling hole after depaneling. We ruled out contamination because the tooling holes were covered during depaneling. Out of three holes, only 2 holes with positioning columns inside have aluminum shreds residue.
Electronics Forum | Tue Aug 01 11:29:02 EDT 2017 | fkn
FKN Systek makes Depanelizers that work on aluminum boards. Please call me at 508 376 2500 or send email to discuss. We usually get a customer sample just to make sure. We have been selling the K3000 and K4000 Depanelizers for over 10 years to custom
Electronics Forum | Mon Jul 31 03:27:21 EDT 2017 | summertang
who can help you to provide PCB cutting machine, need urgently
Electronics Forum | Mon Jul 31 11:06:45 EDT 2017 | capse
Fancort industries offers v-score separation systems. ASYS Group offers sawing and router depanel equipment.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830