Electronics Forum | Fri Feb 13 12:16:05 EST 2004 | Mike Konrad
Ashok, It is most likely not the DI water that is attacking the aluminum rather it is the saponifier. DI water is only in contact with the parts for a relatively short time. If your cleaning process provides for a rapid drying cycle, you should be
Electronics Forum | Tue Oct 07 12:35:10 EDT 2008 | andy_pal
Hi All, I am using COB on my DOUBLE SIDED PCB. lastly we used Eletrolytic Ni / Flash Gold Plating. Our Boards vias Failed the UL corrosion Test. we did some cross-section analysis and found 10.75 �m of Nickel and 0.022 um of Gold and as the Process
Electronics Forum | Wed Jan 10 09:48:13 EST 2018 | mrk
Hi All, Currently we are producing a LED product using an aluminum core MCPCB with surface mount LEDs. In order to achieve better heat dissipation, we are considering transitioning over to a copper core MCPCB. My experience working with copper cor
Electronics Forum | Thu Aug 05 13:03:35 EDT 1999 | Dave Weihrauch
| | | | Has anyone out there tried to parylene coat plastic parts prior to soldering them to a pcb? I'm looking at several potential applications where fewer than 5% of my components on a pcb are plastic, yet from a reliability aspect (environmental
Electronics Forum | Fri Aug 06 07:18:48 EDT 1999 | Graham Naisbitt
| | | | | Has anyone out there tried to parylene coat plastic parts prior to soldering them to a pcb? I'm looking at several potential applications where fewer than 5% of my components on a pcb are plastic, yet from a reliability aspect (environmenta
Electronics Forum | Wed Dec 17 17:57:51 EST 2003 | davef
9. * Conversion coatings are very nice "paints" that allow other paints to stick to aluminum. Type 1 coatings are thicker than Type 3, which are whisper thin. Alodine 120X (Amchem) and Iridite 14-2 (Allied Research Products) are good conversion coa
Electronics Forum | Fri May 21 12:24:21 EDT 1999 | KA Stillings
I normally handle the soldering issues for this facility but a question was asked of me -- What the H@## is this stuff and what is causing it? Was wondering of I could get some input from any Guru on plating issues. Need info ASAP!!!!!!!!!!!!!!!!!!!
Electronics Forum | Mon Aug 27 15:06:29 EDT 2001 | davef
This otta push Wolfgang over the top ... Recommended reading G.G. Harman, Wire Bonding in Microelectronics : Materials, Processes, Reliability, and Yield, 2nd edition, McGraw-Hill Electronic Packaging and Interconnection Series, 1997. G.G. Harman, R
Electronics Forum | Fri May 21 15:20:26 EDT 1999 | JohnW
| I normally handle the soldering issues for this facility but a question was asked of me -- What the H@## is this stuff and what is causing it? Was wondering of I could get some input from any Guru on plating issues. Need info ASAP!!!!!!!!!!!!!!!!!
Electronics Forum | Tue Feb 19 19:36:21 EST 2002 | davef
You weren�t clear but I assume the problem is not widely distributed and affects only a few parts on each board. Do this trick: * Cut a ~1� piece of fairly serious wire, like 18 or 12 AWG. * Strip the insulation. * Gear-up with gloves, glasses, and
.gif)
