Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Thu Aug 29 11:56:21 EDT 2013 | kdc45
Sent program to a CP43 and the part data was not recognized. Machine message to power down and back up, so we did so. On power up, screen appeared with the following: OS Error Err Code 0001 Err task 0028 Err para FFFF Ex stat 0151 Err adrs CC400000
Electronics Forum | Sat Jan 20 17:41:11 EST 2007 | bvdb
Hoping someone can help us. Our Fuji IP-1 won't boot up unless we disconnect the 25 pin RS232 connector that runs to the MCS16/F programming computer. It doesn't matter if the 9 pin connector on the other end of the cable is plugged into the MCS16/
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Mon Mar 29 12:29:05 EST 2004 | Donn Bellmore
Placement pressure can be checked by using load cells. Both PCP and Entran make them and the amplifiers. They can be contacted at the following websites. PCP http://www.pcp.com Entran http://www.entran.com
Electronics Forum | Mon Jul 27 20:35:13 EDT 2009 | michaellaw
This is the common problem for RH6 m/c.You need to check of the following: 1)Make sure the spiral corl is secure properly especially near to detection amplifier box 2)you may try to fine tuning the sensibility VR on the detection card. 3)change the t
Electronics Forum | Tue Feb 21 18:32:12 EST 2012 | skatemo
Hello estimated Someone can help me with a problem that I have in one cp643 which marks the stations 17 and 19 of almost all the holders, already there changed the amplifiers of both stations and were calibrated but it follows the problem. Thanks.
Electronics Forum | Thu May 23 12:27:19 EDT 2019 | weglimir
Hello I have problem with card: VPM-5238D - Namely when printer starts, and DEK program initializes, it hangs for a while on "Downloading vision system" and then following error appears: "Vision Hardware Error - FATAL ERROR - REINITALIZE MACHINE" "
Electronics Forum | Mon Jul 27 20:35:40 EDT 2009 | michaellaw
Just curious if anyone here has experience with a > Panasert RH6 Radial Insertion machine. Ours is > having some problems detecting insertion, appears > to be failing to sense when the legs are cut and > is triggering the error. This is the com
Electronics Forum | Sun Jun 10 12:15:37 EDT 2001 | procon
Hello Danial, Leave it up to most to blame the relow oven for their tombstoning problems when in fact it is usually the last to cause it. The biggest culprit of tombstoning is the pad design followed by the print quality. Usually, we find that the p
