Electronics Forum | Tue Jul 27 23:09:00 EDT 2004 | pdeuel
No.
Electronics Forum | Tue Jul 27 06:31:37 EDT 2004 | sagar
h i built 2 tda1554 22w amps n wanna connect them together to get max power can the output of one amp given in the input of th e other to get high amplification
Electronics Forum | Sat Jul 27 10:00:28 EDT 2002 | benny
Looking for operational amplifier that working on 5V
Electronics Forum | Mon Sep 30 09:47:37 EDT 2002 | Zoran
Hi, I was wondering whether anyone could explain to me, point me in the right direction or send me a schematic on how to build Current Amplifiers. I am building a automated temperature controlled cooling unit and I need to build a current amplifier
Electronics Forum | Thu May 21 20:25:26 EDT 2009 | voytek
I had to replace two Y-axis servo amplifiers on our GSM1 machine. I'm sitting on two faulty servos that I would like to have repaired. Let me know if you now place which specializes in repair of Servo Amplifiers Mod. No. 800-444 by Copley Controls.
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Sun Jul 09 03:05:14 EDT 2000 | Ben
Hi Hermie, Did you perform a Servo-zero-adjustment and Gain calibration on the amplifier after replaced it ? This is necessary fine turning when replacing the amplifier. You had better ask Fuji service center for the procedure. Hope this help you.
Electronics Forum | Sun Aug 07 09:18:07 EDT 2011 | jjcarver
amplifiere error states, Amplifier setup error, programming during startup failed.. Cannot get machine to initiate anyone have this problem?? machine is a MYDATA19e
Electronics Forum | Wed Jan 29 13:01:04 EST 2014 | tech1
Back when the Linear Y wagons first came out Mydata had problem with the original Y amplifier and were swapping out the complete box for customers who had problems. There was also a problem with the encoder that resulted in the same type of errors yo
Electronics Forum | Mon Feb 12 17:16:04 EST 2024 | bobpan
The width motor gets power from an amplifier SPA2100S. I would check the amplifier. It also has the encoder plug into MT1 card at enc3 input.
winsouce.jpg)