Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Tue Jul 02 10:34:48 EDT 2019 | dman97
You should be using the diagram on page 4. 9pin to 25 pin. Flexa settings should be set to NT C/C. You have to make sure that the COM settings in windows are set correctly for the USB adapter you are using. Whatever COM port windows assigns to the US
Electronics Forum | Tue Jul 02 11:04:20 EDT 2019 | dman97
The pin outs are not mirrored. The proper data files usually come on a disk and are usually inside one of the cabinets on the machine. Chances are that the proper data disk is MCS formatted. In order to extract the proper data from the disk you woul
Electronics Forum | Thu Jun 20 05:50:48 EDT 2019 | bukas
Hello everyone, I'm out on market for wave soldering machine. I have been using ERSA 330 ETS for three years now, but it is quite old and I would like something newer. I'm considering ERSA N wave 330, yom 2005; and SEHO PowerWave 8440, yom 2010. Wha
Electronics Forum | Sun Jun 23 17:27:29 EDT 2019 | emanuel
Cyberoptics cameras and laser alignment systems are very popular and used in a lot of machines. So weird, but there is absolutely no technical information available and even in the company's web site they don't exist. Some models like the Hawkeye cam
Electronics Forum | Wed Jul 10 22:13:45 EDT 2019 | SMTA-Ray
I don't recall if the heater wattage is the same or not for the different pots. If the wattage is different then the PID algorithm is also different. this anticipated when & by how much the heater will overshoot its setpoint and turns the heater off
Electronics Forum | Fri Aug 23 02:29:16 EDT 2019 | sssamw
It seems because the soldering area is not enough, so the wetting force is small to hold the switch, remember >0.08g/mm2 for each part as in IPC standard. So, anyway, you need increase the soldering area to reduce weight/area number to below 0.08g
Electronics Forum | Thu Jun 27 12:45:03 EDT 2019 | jmoote
We have two Topaz machines,and use them regularly. However, we have a board that contains a standoff and a large electrolytic cap, and one is 11.2 mm high, the other 13mm. Is it at all possible to modify or upgrade the Topaz to handle these parts?
Electronics Forum | Mon Jul 01 03:40:02 EDT 2019 | robl
Hi Janet, You could pick up an Emerald very cheaply these days, which is very similar except has 2 heads and can go to 15-17mm high. May be cheaper than trying to modify a topaz & vision system. Same software, feeders etc.
Electronics Forum | Fri Apr 17 18:39:20 EDT 2020 | kumarb
You will have to bit-copy the original hard drive contents as there are some hidden registry keys on Windows for their software. In our case, the loss of the motherboard coin cell battery resulted in the software thinking that the license had expired
