Electronics Forum | Tue Aug 02 22:44:42 EDT 2005 | crishan
Thanks for the comments everyone. I did not think of checking the nozzles material, I will check this out. GS, What is PBM, is this some sort of ironiser. Also to clarify, we believe the that the pocket size for the component is too big allowing th
Electronics Forum | Wed Aug 03 10:01:39 EDT 2005 | GS
Hi Crishan, sorry, "pbm" is a short way to say problem. In the past ('89), we had same magnetic pbm also with metal nozlles on Dynaper MPS-2500. Some time, we found also chips received from supllier already magnetized. Solution was to put the r
Electronics Forum | Wed Aug 03 21:00:12 EDT 2005 | rcarlos28
Crishan, Do you check the Nozzle orientation? some machine use a Rectangular o circle nozzle body, and this reduce the vaccum. When this component is taked from the feeder and the camara measured recognized the pins? Do you change the type of rec
Electronics Forum | Thu Aug 04 11:31:45 EDT 2005 | lloyd
I'm not overly familiar with the Pana machines but I recently had the same issue with a SOT23. We have an option on our machines to switch on an early vacuum on pickup and it was this that was causing the problem. I'm not overly sure how it caused th
Electronics Forum | Fri Jul 29 12:26:41 EDT 2005 | DannyJ
Good day everyone, I'm hoping that there are a few of the Westek Ionic Contamination Tester systems out there... I am in need of standardization solution for this unit and my current suppliers have dried up. I was purchasing from Stoelting, #1-67
Electronics Forum | Mon Mar 06 10:59:42 EST 2006 | ezamborsky
Sorry to hear of your problems with your VPI-1000. As most people know the VPI line was transfered over to the Easy Braid Company last July. With most changes of this type there can be some initial confusion and and unneccessary stress placed on endu
Electronics Forum | Wed Mar 08 11:59:10 EST 2006 | c_nguyen
Hi Folks, Does anyone know whether the following machine can do Lead-Free BGA rework? Also how much you would recommend to pay for this machine? Please advice! Your input is greatly appreciated. ================================================ Air-Va
Electronics Forum | Wed Mar 08 11:59:18 EST 2006 | c_nguyen
Hi Folks, Does anyone know whether the following machine can do Lead-Free BGA rework? Also how much you would recommend to pay for this machine? Please advice! Your input is greatly appreciated. ================================================ Air-Va
Electronics Forum | Wed Mar 08 15:37:28 EST 2006 | Mike H
I think Peter gave up since I have not seen anything from him since original question on comparing Metcal to Airvac. I personally prefer SRT to either of these two. SRT proven that the software and its' semi or full auto operation is superior to any
Electronics Forum | Tue Aug 15 00:46:21 EDT 2006 | ahmad
Guys I do not know what you guys are trying to prove. If you have a BGA job to be done JUST forget about using any equipment that is using hot air since you will get into a lot of trouble. It will bend the PCB and need nozzole for each IC find an ER