Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Tue Feb 24 03:36:37 EST 2015 | jlawson
Also should look at Viscom 3088Flex Ultra if after AOI with 3D capability. The camera optics module has many innovative features, super fast data capture - much faster then Mirtek and KohYoung. Both these companies have taken 3DSPI and turned into AO
Electronics Forum | Thu Feb 12 03:33:00 EST 2015 | shahrat
I am planning to bye AOI machine for my first SMT line. Mirtek & Kohyoung both has quoted me.Considering price & performance which machine should I go with.
Electronics Forum | Thu Feb 12 14:45:10 EST 2015 | barryg
I can only speak for Mirtec, and no I am not affiliated with them at all. We have had a Mirtec AOI for at least 9 years. We have never had any major issues with it. There support is very good and usually they get right back with you if you cannot get
Electronics Forum | Tue Feb 17 00:18:33 EST 2015 | shahrat
I am planning to bye MV7-omni. What do you think of this machine?
Electronics Forum | Thu Feb 12 16:42:33 EST 2015 | hegemon
I can only speak for Mirtec and Yestech AOI for SMT Solder Inspection. We do use Koh-Young AOI for Solder Paste Inspection. As usual ,you need to identify exactly what it is you are trying to achieve with your AOI, if you are just trying to fill a
Electronics Forum | Thu Feb 12 21:14:37 EST 2015 | kahrpr
They are both very good machines however Kohyoung will give you better first pass results meaning a lot less false calls and when you run the first board after initial programming you have to fix very few things. However the cost is a lot more. This
Electronics Forum | Tue Mar 03 16:27:53 EST 2015 | emeto
As Lokit mentioned, the support and spare parts are important. Support for Mirtec has always been very fast responding, but the spare parts are different story. Last two times I needed spare part it took them two weeks(parts are coming from Korea)
Electronics Forum | Tue Feb 17 12:58:11 EST 2015 | anvil1021
The MV-7 OMNI is a Great Machine, has the same 3D Solution MV-9 Quad Moire Multi Frequency System. You will not be disappointed, you will find new ways to use the 3D system as time goes on and it is rock stable and incredibly precise. Either the MV-
.png)
