Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Fri Sep 20 14:23:50 EDT 2002 | larryk
PizzaFred, Scott mentioned lots of good ideas. Take one of your boards to each vendor and see what it takes to program the board how long it takes for it to become online. I've found some that are easy to program, but require 40 or more assemblies to
Electronics Forum | Fri Apr 21 18:43:23 EDT 2006 | SD
Sorry, I have not read the article. However, I do have five years experience constantly tweaking an AOI system that ran ONE product! The strength of the machine was solder inspection. The biggest problem was component color variation and shadowing
Electronics Forum | Wed Aug 30 07:34:23 EDT 2006 | Xray Tester
For Automated x-ray inpsection system comes in 2D and 3D. 2D also know as the transmission xray inspection where xray are generated from a fixed point source. On double side board, this does not work that well. That where 3D Automated x-ray inpsectio
Electronics Forum | Tue Aug 21 21:11:29 EDT 2001 | davef
It depends on what you're doing. Say for component placement verification, a line that's kicking-butt might have time to look at a somewhat different quarter of each board, depending on lots of stuff [eg, board, AOI equipment, line rate, etc.]
Electronics Forum | Thu Aug 23 21:00:10 EDT 2001 | davef
We do the same quadrent every four boards in placement inspection on a Orbotech.
Electronics Forum | Thu Apr 19 18:03:56 EDT 2018 | spikesnpearls
hello i am a new aoi programmer and i was wondering how to choose/change what type of lighting it uses while scanning the board.i use a yestech ytv-fx
Electronics Forum | Fri Aug 03 09:21:08 EDT 2001 | Ian T
hi my company is planing to purchase an aoi system to be used inline. is there anyone out there doing this, if so do you use all the machine options (pattern character recognition, bad board marks, correct part polarity...) or do you dumb it down(pa
Electronics Forum | Wed Jan 24 21:29:43 EST 2007 | davef
Board fabricators commonly use Barco AOI to inspect film. The AccuMatch compares pixel-to-pixel of the Gerber data to the image seen by the AOI camera. It's slower than design rule checking, but has definite advantages [like lower falsing]. Unfortu
Electronics Forum | Wed Aug 22 12:30:34 EDT 2001 | slthomas
Now that's an approach I've never thought of, inspecting a different portion of each board (I'm assuming that you program a few different patterns and run them sequencially, or something like that). I know our stencil printers don't provide that opti
