Electronics Forum | Wed Jun 27 12:51:53 EDT 2012 | cyber_wolf
You can leave the booster in the original position and mount two small fans directly underneanth it blowing upward. By leaving it in the original upright position you get quite a bit of air velocity in the small space between the booster and the mach
Electronics Forum | Wed Feb 28 15:11:45 EST 2024 | emeto
Hello all, I have a flux over components that affects AOI results in reading the symbols on top of it. What would you recommend to minimize this effect?
Electronics Forum | Sat Dec 09 08:32:25 EST 2006 | davef
Thoughts are: * Most board fabs have routers that can do this work. Can yours rework these boards? * Scrap the boards and start anew. Someone made a mistake. Cut your losses. * As a wild and crazy guy alternative, buy a router with a 45* bit from
Electronics Forum | Wed Mar 16 02:48:08 EDT 2016 | ermani9
Hi, Can any body help me in calibration and programming of AOI machine Vi-5000?
Electronics Forum | Tue Jul 25 14:30:04 EDT 2017 | emeto
Looks like you have a great wetting of your paste :). Once body has been in contact with molten solder, the package could suffer damages on the body(outside and inside) and on the circuitry inside. It is considered a defect. I have seen that before a
Electronics Forum | Tue Oct 18 15:50:01 EDT 2022 | smith88
IPC states chips and cracks in glass body are defective if beyond specifications. Chips or cracks in glass body beyond the part specification, see Figure 9-18. • Cracked or damaged glass bead beyond part specification (not shown). On some glass
Electronics Forum | Sun Dec 08 09:59:39 EST 2013 | davef
Component fabricator is concerned about the temperature of the lead at the point where the lead enters the component body. So, if you sink temperature at that point, you will assure a lower chance of damaging the component.
Electronics Forum | Thu Aug 06 23:47:14 EDT 2015 | anilwagh
I have Orbotech AOI Trion2340EXP. Machine hard disk damaged and we are loaded machine software on hard disk. Need to communicate system file like config.sys and others. Please any one suggest.
Electronics Forum | Thu Apr 27 05:45:20 EDT 2017 | pavel_murtishev
methos1979, 1. Mirtec, Marantz 2. Koh Young, Orbotech, Mirtec 3. Koh Young Zenith 4. Definitely Programs for 3D AOI are prepared really faster. Having defined component database, programming takes no more than a couple of hours. Fine tuning takes u
Electronics Forum | Sat Sep 02 00:22:44 EDT 2017 | ermani9
I have Solder Paste Inspection Machine of TRI make, which accepts the SMT pads CAD data in the .lst, .aoi, .srf or .asc formats only. Can any body suggest how to convert my existing data in .gbr or .gbx into the above reqd. formats. Pl suggest. Tha