Electronics Forum | Thu Mar 30 10:02:03 EDT 2017 | Bestglobal SMT
We have a 2008 DEK horizon 03i this machine has been a very reliable system. we are having an issue with the print being offset in the x .2mm I have run 4 different boards - same issue on all. same offset. i can print the board 10 times over and
Electronics Forum | Mon Apr 19 21:37:17 EDT 2021 | ouaret
dear all, update: we got that the calibration of SIM is the problem, the distance between SIMs need to be calibrated. can someone help us get the manual that describe on how to calibrate the SIMs? we have a problem with our cyberoptics AOI machine
Electronics Forum | Thu Sep 11 17:28:57 EDT 2014 | grsysservice
Dear all, we are company here in Brazil that is looking for a Genesis calibration kit MCCM Calibration kit 45235202,if some one has one to sell we can travel to get it.
Electronics Forum | Mon May 02 10:36:22 EDT 2016 | ilavu
Where are you located? I have calibration kit and some programming experience too.
Electronics Forum | Wed Apr 26 01:59:01 EDT 2023 | ttheis
Thanks, what about the camera calibration? Does it use the same kit as the GSM machines?
Electronics Forum | Tue May 03 00:03:30 EDT 2016 | ermani9
Hi.. Tushar, We are located in Chandigarh (India). We have our calibration kit too. Even performed Calibration also. But could not proceed for programming. Tried a lot but failing..
Electronics Forum | Mon Jan 29 11:19:09 EST 2007 | SWAG
That's what I'm talking about. Might need to calibrate, then. We usually rent a cal. kit and do the cal. ourselves. Just make sure you specify your block, head configuration, etc. when renting. As for frequency, we generally don't worry about it
Electronics Forum | Fri Dec 09 17:57:16 EST 2005 | mika
cameras > P2P (Part to Pad looking camera or upper looking camera) > front or rear >> select the corresponding camera that You have installed. After that: just save and follow the instructions on the screeen. By the way, an important thing is: You M
Electronics Forum | Fri Oct 11 09:34:15 EDT 2024 | carl_p
Can't fault the Koh Youngs the 8030 was a faultless piece of kit. Never used them as AOI's yet - at the last time of purchase they couldn't do what was required so we had to opt for the cyber optics offering as it was the only piece of kit on the ma
Electronics Forum | Sat Apr 29 12:18:07 EDT 2023 | poly
I have finally got a calibration kit for my single beam multi function Genesis. Calibration finishes successfully, I then attempt to pick a part with the 7 spindle head and it gives me a collision error. The error occurs even when I don't have a no
