Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Fri Oct 07 13:03:11 EDT 2011 | wrongway
Hello all i am getting ready to by a A.O.I. machine brand new i don't think it will be yestech now
Electronics Forum | Mon Oct 10 15:07:18 EDT 2011 | kahrpr
An extraction system is not a good comparison. The extractor itself is not where they make their money. It’s off of the consumables filters etc. Aois and other larger capital equipment there is no other income stream after the sale other than a few p
Electronics Forum | Tue Oct 04 17:38:55 EDT 2011 | frcdave
I would like to throw my $0.02 in here as well. $15,000 to register a used system seems like a lot of money, I agree, but on the other hand, why would one expect that service and support should be free or even at a discounted price. Like the other p
Electronics Forum | Mon Oct 10 08:26:08 EDT 2011 | martinouk
We have two YesTek AOI systems, and the reason we have two is because of the quality of performance and the support we received on the first system. The YesTek systems are good...but let me share this experinece with you 'fishingfool'. We bought a
Electronics Forum | Mon Oct 10 08:28:06 EDT 2011 | martinouk
We have two YesTek AOI systems, and the reason we have two is because of the quality of performance and the support we received on the first system. The YesTek systems are good...but let me share this experinece with you 'fishingfool'. We bought a
Electronics Forum | Thu Jul 01 16:26:44 EDT 2021 | willkillum
shop@esuinc.com
Electronics Forum | Thu May 13 20:20:08 EDT 2021 | victorzubashev
Hi, you can also consider VISCOM S3088 3D AOI. I installed last year for CM client with High mix low volume. They have a very powerful and user-friendly programming interface.
Electronics Forum | Wed Oct 22 01:14:04 EDT 2008 | maheshbs
Conveyor is installed after AOI machine. After inspecting the board in AOI it sends the signal to the conveyor whether it is Good board or Bad board.
winsouce.jpg)
