Electronics Forum | Sat Aug 19 21:06:09 EDT 2006 | mika
Hi all, At our Fuji CP-6 machines we place a lot of 0402:s, 0603:s and 0805:s chip capacitors. Our problem is that the height of the components can sometime be very extreme from different vendors. I am sure you all have experience of this phenomenon
Electronics Forum | Mon Oct 28 07:07:39 EST 2002 | cyber_wolf
It has been my experience that when all conditions are as they are supposed to be there should be zero or very little deflection. When you start placing components with pick and place equipment that does not have a Z pressure sense, you run the possi
Electronics Forum | Wed Oct 30 01:23:22 EST 2002 | jasper
It has been my experience that when all > conditions are as they are supposed to be there > should be zero or very little deflection. When > you start placing components with pick and place > equipment that does not have a Z pressure sense, > yo
Electronics Forum | Sun Jul 25 08:54:37 EDT 1999 | Tom Gervascio
| We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after
Electronics Forum | Mon Jul 26 10:25:12 EDT 1999 | Boca
| | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that a
Electronics Forum | Mon Jul 26 14:14:51 EDT 1999 | Steve Gregory
| | | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is th
Electronics Forum | Wed Jul 14 20:13:33 EDT 2004 | engineerx
Hi, I've been evaluting a few AOI for my company including Cyberoptic. Of those, Orbotech do provide workstation for verification purpose.Some AOI inspection time might vary with the size of the board.
Electronics Forum | Tue Aug 15 05:03:30 EDT 2023 | alishakihn
When it comes to F1 AOI (Automated Optical Inspection) machines, there are various models and manufacturers available on the market. While specific features and capabilities may vary between different F1 models, here are some general factors to consi
Electronics Forum | Wed Nov 07 20:01:35 EST 2007 | davef
Josh: Hole size to lead diameter ratio is meaningless. Minimum and maximum component lead to finished hole size clearance do not vary according to component lead diameter or hole size. Regardless, here's what you want to smack those goofballs over i
Electronics Forum | Wed Aug 22 16:00:02 EDT 2007 | razor1
The color variation in the solder mask from our PCB supplier varies to the point that we have problems with our AOI recognition and accuracy. We have not been successful at finding an industry spec which outlines solder mask color requirements. We
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
