Electronics Forum | Thu Sep 19 16:58:04 EDT 2002 | dragonslayr
You definitely need to have live demos of each system, using your specific assembly if you want to compare apples to apples. Each of the AOI OEM's you mentioned have plus amd minus to their unique systems. You will need to evaluate your specific nee
Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Fri Nov 06 02:55:10 EST 2015 | arct1c
Hi, we are looking for 1 or 2 new postreflow AOI machines to replace our old ones and possibly 1 prereflow AOI(we never had pre reflow before). In our company we run low volumes and high volumes. I have been looking at Viscom, Mirtec mostly, Cyberop
Electronics Forum | Thu Mar 22 20:56:50 EDT 2018 | jacobidiego
Hi experts, I have some multiple and randomly missing components after reflow. PADs are seen in AOI as if the component was never there. I have seen no evidence of the chipmounters missing any components at all while populating the board. We don't ha
Electronics Forum | Tue Nov 10 15:25:37 EST 2015 | 31258
Good morning RedChili, This is Marvin from Saki America. I came across your post and I noticed that you are interested on 3D-AOI and 2D-AOI machines. We can offer pre-reflow and post-reflow full 3D-AOI and 2D-AOI for you needs. IF you have any ques
Electronics Forum | Fri Nov 06 07:46:33 EST 2015 | clampron
Good Morning RedChilli, I have worked with Mirtec for quite a few years. I have looked at some of the other machines mentioned but have no practical experience with them. I started with the Mirtec MV-2 (long ago)due to the success of this platform,
Electronics Forum | Wed Feb 20 11:40:31 EST 2019 | bmalhi
Heller Oven comes with a profile pre-loaded so you can start there. RTS = Ramp to Spike. Basically a straight line from preheat to spike. Also known as “Tent” profile RSS = Ramp Soak Spike. This one creates a flat line around 150-180 degrees on th
Electronics Forum | Mon Apr 01 08:09:36 EDT 2013 | babe7362000
We currently have an AOI after reflow, and I was wondering how others have thier line setup? Does the AOI operator have to get up and get a board from the oven to run, or should the SMT operator hand the AOI operator a board. The AOI operator does
Electronics Forum | Mon Apr 01 10:09:03 EDT 2013 | markhoch
It sounds as if you have your AOI set up off-line, and you're "AOIing" a sampling of the PCBs produced. If that’s the case, then the responsibility of who drives the inspection really depends on how you configure it. If it's based on the number of P
