265 aoi problem results

Electronics Forum: aoi problem (Page 1 of 27)

Mirtec aoi

Electronics Forum | Thu Nov 01 02:45:47 EDT 2007 | laplooi

Whe have the Mirtec about 2 years now, the question is, that when you have 100 components to check he give's 20 to 30 failures that no failures are. are there people they have the same problem?

Mirtec aoi

Electronics Forum | Thu Nov 01 09:23:27 EDT 2007 | pjc

If you are in the Americas, I'd contact tech support and they should square you away on that high false call rate problem. They have great WebEx training and troubleshooting. www.mirtecusa.com

aoi inline

Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker

Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of

Reflow problem

Electronics Forum | Wed Sep 26 11:17:38 EDT 2012 | garym4569

We have been having a solder paste reflow issue which results in the solder not wetting to the LED lead. The solder appears to create "puddles" on the pcb pad. I have attached AOI image for review. We have had the pads analyzed for contamination, w

AOI photondynamic 7750 problem

Electronics Forum | Sat May 28 02:52:17 EDT 2005 | ajaydoshi

We have AOI photondynamic 7750. Problem 1. it hang very often. 2. During starting of day x axix does not move. we need to move manually & then start otherwise it will not move by machine motor. ajay

Koh young AOI problem

Electronics Forum | Fri Mar 26 08:55:45 EDT 2021 | manaik

Hello, We have purchased used Koh Young AOI, the setup does not let us through when you start MCS on start, it says RJ45 connector is out, which is not. delta tau clipper conntroller. The swithc on INIT must be ON or OFF? Do the lights work even wi