Electronics Forum | Mon Sep 23 13:08:47 EDT 2002 | dragonslayr
Daan has made a valid point with regards to expertise and use of a machine. Yet I recognize that with advanced technology, trades must occur. A hghly sophisticated AOI unit can and will help reduce overall cost of production. Therefore, a need to ha
Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Mon Aug 27 16:13:35 EDT 2001 | seand
Hello Everyone, For QC purposes, there are a couple of methods to both qaulitatively and quantitatively inspect your manufacturing process. For Paste inspcetion, an inline machine like the SE300 by CyberOptics may be appropriate. You may also inco
Electronics Forum | Fri Sep 02 19:31:40 EDT 2011 | jlawson
I agree that if information is processed correctly up front in process down stream QA becomes less expensive ie AOI etc as AOI at end of lines is telling you you have made mistakes in up stream. I better to eliminate mistakes or have process to avoid
Electronics Forum | Wed Aug 31 08:27:45 EDT 2011 | rway
AOI if needed? I take it your AOI/AXI is not inline. Too bad. Our AOI is the first line of defense against induced errors in the mfg process. It's invaluable. How do you know it's not needed, or that it won't be needed in the future? Do you hav
Electronics Forum | Mon May 13 06:15:12 EDT 2019 | dhanish
how to control warpage on panelized pcb during reflow process.we are already running with pallet.Encountering problem to insert the pcb into pallet after first reflow cycle.The insertion is being done by robotic arm. Any recommendation on the profile
Electronics Forum | Thu May 23 10:21:19 EDT 2019 | emeto
What is the material of this PCB?
Electronics Forum | Mon Jul 01 04:39:49 EDT 2019 | sssamw
yes, You need tell us how the PCB and board designed, size, material, how de-paneling the PCB?
Electronics Forum | Mon May 13 06:38:41 EDT 2019 | relaycz
You need to give us a little more information. 1. What is the size of your panel? 2. Are there any heavy components? 3. What is the thickness of your board panel? 4. What kind of oven are you using? 5. Is it only a recent problem or ongoing one?