Electronics Forum | Mon Oct 20 15:28:22 EDT 2014 | island2013
We've got a set of manuals here for the AP series. If you would like to borrow them email me.
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.
Electronics Forum | Thu Jun 12 00:20:41 EDT 2014 | jasmine01
How to limt my Cisco WS-C3560X-48T-S switch port to 128kb which running 12.2(55)SE3 ? Could anyone help with the IOS commands needed to achieve this ?
Electronics Forum | Mon Nov 25 20:52:47 EST 2019 | cbeneat
Are the arms pulling the cart all the way in? Possible part blocking the limit switch. does the cord have power? If I remember correctly, we once had to adjust the mechanical stops on one of ours so it would make the switch.
Electronics Forum | Fri Aug 11 11:18:20 EDT 2006 | chrisgriffin
I got a 3000 that is acting crazy. After a print, the board is unclamped and the Z-axis lowers. It continues to lower until it trips the limit switch. It is suppposed to move in the Y-axis to line up with the tracks while lowering in the Z-axis.
Electronics Forum | Wed Jul 20 16:49:44 EDT 2005 | Pete Roy
We have two APS Gold ovens and are acheiving an accpetable Lead Free profile. We still have to further qualify board widths/sizes to determine what are limits are and still be within the profile we need. For the most part you need more zones/longer t
Electronics Forum | Fri Feb 13 09:25:35 EST 2004 | jcdupree
Hi Patrick, I can easily troubleshoot ML, EL and SL 20 systems by phone or e-mail, but the MPC-29 is a bit more complex. The problem that you are describing was failry common, and there were a number of potential causes. First is to check if the dr
Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
Electronics Forum | Mon Apr 08 07:20:56 EDT 2013 | leemeyer
What operating system are you using ? I have found that you need to stay with a DOS based operating system. I am running DOS 6.2 with windows 3.11. I tried win 98 and although it seemed to run properly, I would have problems in the final program. XP
