Electronics Forum | Thu Aug 17 19:29:54 EDT 2006 | foxhound
Im having problems with my ap 25. I get the air pressure fault alarm when it boots up so I bypassed the air pressure switch but I still get the alarm. The air routes through the machine as soon as I hit the on button, I thought it wasnt suppose to
Electronics Forum | Thu Apr 14 16:18:27 EDT 2005 | jdengler
Also check pressure switch. They sometimes fail.
Electronics Forum | Thu May 01 06:35:51 EDT 2008 | kevinjm
Hi Jim, We had a similar problem with an AP-27. You could try to jumper the wires which lead in to the reed switch. Failing that you could swap out the opto module for this, in our machine it's located in rack 2-15. Rgards, Kev.
Electronics Forum | Mon Oct 31 03:35:41 EST 2005 | pavel_murtishev
Good day, I simply switched the production from MPM to other printing machine. Defect disappeared. Process parameters and process materials were the same. Stencil was the same. �Dog hides� somewhere in the machine. BR, Pavel
Electronics Forum | Mon Mar 05 15:24:41 EST 2007 | Hussman
Well, there you have it Pavel, Tim says to switch to DEK. Start packing up your MPM.
Electronics Forum | Tue Mar 18 14:29:46 EDT 2008 | chrisgriffin
That AP can paste 0201's and has built in 2D. I would keep it. The AP series "forcers and platens" design is a bit fragile, but reliable and tends to last a long time. My biggest complaint is the cheap air hoses to the 3 forcers. After about 8 ye
Electronics Forum | Mon Sep 10 11:00:11 EDT 2007 | mgrimes
Chris, Appreciate the response - we set FP to "1" last week but no help. The drift is only in the X as well - the Y is never off. We have tried switching the cards to see if if the problem goes to the Y but it doesn't - stays in the X. As for the b
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Mon Jul 26 22:14:22 EDT 2004 | pdeuel
Cognex version drives the vidio. If you are getting an image then cognex is not an issue. Thru bore calibration of the camera is the alignment of the upward looking with respect to the downward looking. One camera dose it all getting the image thru o
Electronics Forum | Thu Mar 23 10:02:09 EST 2006 | Joe
Check placement pressure. I agree with the "smushing" theory. If you can place the component with less pressure, I'd do that first. A switch to Type three paste is also a good idea, as long as your minimum aperture dimension remains at 0.009" as you
