Electronics Forum | Tue Mar 11 10:17:49 EDT 2008 | cyber_wolf
Does anyone know where I can get these aside from speedline ? I am having some difficulty locating them. They are 1.74 ea from Speedline. Only one problem...Speedline has this cute little $100 minimum order thing. Nice.....
Electronics Forum | Tue Mar 11 10:24:31 EDT 2008 | mgrimes
Is this what you are looking for? http://www.mouser.com/Search/Refine.aspx?Ntt=*560EWG103*&N=1323038&Ntx=mode%2bmatchall&Ns=P_SField∨iginalKeyword=560-EWG103&Ntk=Mouser_Wildcards
Electronics Forum | Fri Jun 20 13:33:34 EDT 2008 | vms
Look into the up2000's and the AP25 printers of MPM. On the used market you should find them for approx. 20kusd. Just buy one that has a warranty. Harry
Electronics Forum | Mon Oct 12 13:28:56 EDT 2009 | swag
When you teach the fid on the PCB and the camera then changes to stencil image, is it in close physical proximity to the feature/fid you wanted or do you have to move quite a bit?
Electronics Forum | Wed Oct 28 13:29:11 EDT 2009 | swag
Can anyone tell me the command I need to type to get into machine configuration in DOS MpM software? I want to change x/y/theta cal. settings to adjust for vision offset because I don't have the fixtures to do a calibration.
Electronics Forum | Mon Oct 17 16:24:10 EDT 2011 | enttec
Hi Thanks for the reply, which files contain this info ? I've searched around in the filesystem and can't find them
Electronics Forum | Tue Oct 18 17:38:03 EDT 2011 | enttec
Hi Thanks for the info, I'll try that. Can you tell me more about the NT conversion ? Our operators sometimes struggle with doing backups and such on the dos system Thanks
Electronics Forum | Fri Aug 23 14:23:12 EDT 2013 | cyber_wolf
Try re-seating the Cognex card and the connectors that plug into it. Make sure the fans on the drawer are clean and functioning. Ive seen bad camera cables cause this as well.
Electronics Forum | Tue Jul 27 19:37:51 EDT 2004 | simmcircuits
Thank you Paul, this is the actual information I need to adjust the camera! At the moment I have actually reduced the offset values down to 0.7 from a previous 4.0. I have done this by editing the AP.CAL, took a while to get the proper values as I ha
Electronics Forum | Thu Oct 05 19:00:42 EDT 2006 | SWAG
We've always been MpM so no comparison from me on DEK. All I can say is we have had 3000 series that seemed to need constant attention and almost daily wrenching. We got a couple of AP25 HiE's and they are easier to use, way more reliable and simpl
