Electronics Forum | Tue Jun 01 12:48:49 EDT 2004 | pjc
AP25 can handle warped boards to a degree. I also depends on the board clamping system on the machine. There are three avbl. First is Universal Vacuum box, second is dedicated tooling with vacuum and third is Y Snugger tooling that does not use vacuu
Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th
Electronics Forum | Thu Aug 04 03:56:38 EDT 2005 | Rob
Hi Danny, I do remember you recently suggested to a customer who was new to surface mount & wanted low volume the following equipment that you were selling: 1. MPM AP25 2. CP4 3. IP2 http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CF
Electronics Forum | Fri Oct 28 10:04:02 EDT 2005 | valuems
Hello Since we have a few years experience with these printers we might be able to help. Is these problems always with the same components? Is this a new type of paste for you? Is there tape on the bottom of the stencil? And how much pressure do
Electronics Forum | Mon Oct 31 03:42:47 EST 2005 | pavel_murtishev
Good day, Problem appears only with 0.5mm pitch components. Print quality for these components is unacceptable. Paste type isn�t new for us. No any tape on the bottom of the stencil. We apply enough pressure on squeegees, stencil remains clear after
Electronics Forum | Mon Oct 31 14:46:54 EST 2005 | valuems
Hello Did you just buy this machine on the used market? There is a possibility that the stencil is not height on all 4 corners ( from the center nest assembly. I don't under stand " the under stencil wiper is not working correctly". This is about
Electronics Forum | Wed Nov 02 01:53:41 EST 2005 | pavel_murtishev
Hello, Thank you for answer. We are using second hand machine. What do you mean saying that �stencil is not height on all 4 corners�? Does it have some inclination between corners? I mean that three corners of stencil are matching with PCB fine and
Electronics Forum | Wed Nov 02 08:16:31 EST 2005 | pavel_murtishev
Hi! It goes away only for one or two print strokes. After them the problem arises again. After first print stroke I inspect a lot of �dog ears� and a lot of paste not released from the stencil (it�s not a stencil design problem, other machine prints
Electronics Forum | Wed Nov 02 13:24:09 EST 2005 | valuems
Hello Sorry we have not answered sooner, been gone. There is a height adjustment on the wiper. You will find a round nob under it, that is a height adjustment. I expect the wiper is not going all of the way up. And you can also control the speed
Electronics Forum | Thu Nov 03 01:27:10 EST 2005 | pavel_murtishev
Good morning, Our automatic cleaner simply doesn�t clean. When I am inspecting clogged apertures I execute �cycle wiper� command few times. After wiping cycle apertures remain clogged. Zero effect. We tried to use solvent in production to improve cl
.png)
