Electronics Forum | Thu Dec 08 22:35:41 EST 2005 | fastek
Harry- That's true but we weren't hear to discuss what's the cheapest printer around. The guy wants to step up in technology without jumping into the Mercedes-Benz of printing. In my mind any MPM printer below a UP-2000 would not serve his purpose.
Electronics Forum | Fri Apr 21 00:56:44 EDT 2006 | pavel_murtishev
Good morning, MPM AP25 we have is equipped with dedicated vacuum support only, no side snuggers. Also we had a lot of issues with fine pitch paste deposition due to this poor support. Vacuum support can�t fix wrapped boards properly causing a lot of
Electronics Forum | Fri Sep 22 13:03:26 EDT 2006 | daxman
I ran the vision test...here is what I got. Camera System: Completed Repeatability VX mean = -3.177942 Standard Deviation = .000059 VY mean = -12.114077 Standard Deviation = .000065 Vision System: Completed Repeatabi
Electronics Forum | Wed Sep 27 17:06:26 EDT 2006 | daxman
Hey Guys, I checked the histogram...it doesn't look good. I'm assuming the graph for the black bars has to be in the green on the left and the graph for the white card needs to be in the green on the right?? Anyways, I can't find a "GS4 pot" I looke
Electronics Forum | Mon Oct 02 17:31:40 EDT 2006 | daxman
ARGGH! I've verified proper airflow, made sure everything is tight and secure, cleaned and lubricated the bearings and nothing seems to help. first few boards are nice...then the next few are really bad..then they kinda get good again. I have no ide
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
Electronics Forum | Fri Sep 21 16:57:47 EDT 2007 | chrisgriffin
Harry is right. Too much moisture in the air lines screws up the air cards. These pro-heads are somewhat of a pain to calibrate. I think it is a little pre-mature to say you probably need pneumatic cards. You just need to calibrate the pro-head.
Electronics Forum | Tue May 11 10:57:35 EDT 2010 | ehess
Having a problem where i have no drive on any axis. Machine powers up, but won't reset. I have 24VDC from PS6 and PS1, located in the upper drawer. I do not have 12VDC @ PS2 in lower drawer. troubleshooting guide says to check DPR in/out, which I
Electronics Forum | Tue Oct 18 10:07:59 EDT 2011 | swag
We converted all ours to NT so it's been a long time since I did config changes in DOS. Here's what I think I remember from when we had DOS O/S: Exit to DOS and type CD CONFIG in the command line. You should get a full list of configuration settin