Electronics Forum | Fri Aug 23 00:27:07 EDT 2013 | comatose
I have an AP25 printer, which has served us fine for years. A couple days ago the top quarter of the vision display went all "wiggly" and now it won't find fids. The PC and monitor are fine, so its definitely something in the vision system. Before
Electronics Forum | Fri Jan 11 11:01:04 EST 2019 | jbhakta
Hello All, We have a MPM AP25. Couple weeks ago we booted it up and got a "CMOS battery state low" warning. It asked us to fit F1 to RESUME. After that it asks for a ROM password. After incorrectly typing in a password - it asks for Boot Disk in the
Electronics Forum | Tue Aug 25 08:46:03 EDT 2009 | doremiking
I've just seen your question because I list this site rarely. It can boot usually from C: hard drive, we have 4 Omron AOIs - brand new (RNS & VT-WIN2),theoretically one computer can boot from different disks, it is set up in the BIOS, there are some
Electronics Forum | Tue Mar 25 15:16:16 EDT 2014 | yuran111
machine controller BIOS loads only cyclically until pressed reset button on it - now checks the configuration and loading tasks load. hard drive I can take from the controller Siemens s27 example? motherboard came from s27 machine, and the same softw
Electronics Forum | Sun Nov 06 16:10:25 EST 2016 | teslalab2
Hi! I have a Quad IVc pick and place that runs dos. The GUI computer is a compaq prolinea 4/33s. The hard drive went stupid mode and now wont respond. I have all of the data backed up. I tried transferring the files to a fairly modern hard drive (20g
Electronics Forum | Mon Sep 20 11:53:41 EDT 1999 | Scott S. Snider
| HI everyone, | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 and .001
Electronics Forum | Thu Sep 23 21:51:27 EDT 1999 | harry
| | HI everyone, | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 an
Electronics Forum | Fri Aug 03 11:09:23 EDT 2001 | Eric123
I have paste left on my stencil on the forward stroke. I adjusted the downstop pressure but it didn't help. Any suggestions.
Electronics Forum | Fri Sep 20 15:44:00 EDT 2002 | pjc
Do you have a Panasonic & Toshiba camera? What are the MPM p/ns your looking at? Whats the problem? Noise perhaps. If noise try checking the metal cylinder to the right of the camara housing. The set screws can loosen up. Tighten up all the screws.
Electronics Forum | Tue Sep 24 08:47:17 EDT 2002 | pjc
Please send me the s/n of your machine to my mail box and I'll see what I can dig up for you.
