Electronics Forum | Tue Feb 17 15:38:18 EST 2004 | cyber_wolf
I agree with dry wiping. We have 4 SPM's and 2 AP25's, we have never had a need for solvent. I would be cautious using alcohol/ or alcohol based solvents.
Electronics Forum | Fri May 21 14:51:29 EDT 2004 | cyber_wolf
The sprayer is supposed to be aimed at the part of the wiper paper that comes in contact with the stencil.(Not @ the stencil) We have 4 SPM's and 2 AP25's and never had a need to use the solvent sprayer. Dry wiping works just fine. Print on !......
Electronics Forum | Fri Jan 06 07:58:47 EST 2006 | Rob
It attacked our lovely AP25's, can't remember exactly what the fluid was as it was a loooong time ago now, but it was definelty specified by a telecoms OEM.
Electronics Forum | Thu Apr 20 13:55:31 EDT 2006 | cyber_wolf
Here is the problem : We have 2 AP25 printers with dedicated tooling. After we run side one boards through reflow, we get some warpage in our boards occasionally.(Sometimes we get a lot of warp depending on the geometries of the substrate) When the
Electronics Forum | Thu Apr 20 14:24:54 EDT 2006 | pms
Sr.Tech, Don't know about AP25's, we have a DEK. We have problems with some large board sagging in the middle, causing the board to slip under the board stop, but our DEK has the ability to program the board stop anywhere in the Y direction, allowin
Electronics Forum | Tue Aug 29 15:05:16 EDT 2006 | cyber_wolf
We run a lot of double sided boards. So I need a printer that will handle warped boards well. Can anyone tell me which printers work better on warped boards ? Our AP25's are crap on warped boards. If I had a penny for every time our cameras got kno
Electronics Forum | Mon Mar 05 14:44:51 EST 2007 | daxman
Hey, I've seen a lot of AP25's with snuggers. I don't know if they all came with the pneumatics or not..but if you have the snugger reg. guage, just underneath the Z table, you should be okay. The fellas at goppm (www.goppm.com) have a lot of knowl
Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th
Electronics Forum | Fri Sep 22 13:21:26 EDT 2006 | cyber_wolf
Dax, Just an FYI....we have had AP25's for years. I have never had to calibrate them. Also, I am not a MPM service guy but I would have to say that if your standard deviation numbers are coming up less than .001" you are doing ok there. Sounds to m
Electronics Forum | Tue Oct 18 17:54:53 EDT 2011 | swag
Yea, it's tough and takes 25 disks. Not sure if there's a better way. As for NT, we bought NT upgrade packages from Speedline for all three of our AP25's. The backup is then done on a CD burner. I can't remember the cost of it all. However, be a
