Electronics Forum | Sat Oct 15 19:18:14 EDT 2011 | enttec
Hi Does anyone have a calibration manual for a MPM AP25-Hie ? Have noticed recently that we have a slight mismatch between board and stencil when printing. I have the user manual but we didn't get calibration when we bought this machine Thanks Nic
Electronics Forum | Mon Aug 31 15:39:18 EDT 2020 | jmelson
Yes, the rightmost VME board is the IO_DPRAM, and it also handles the front panel buttons and E-stop inputs to the computer(s). So, reseat the connectors on the front of that board. Also, there may be an interface board on the bottom left (called C
Electronics Forum | Mon Aug 31 12:01:14 EDT 2020 | inspiredmorris20
Thank you bukas, I have not tried to unslot the computer boards. Are you referring to unplug the hardware connections to each circuit board and reconnect them? Thanks again for the reply!!!
Electronics Forum | Mon Aug 31 19:53:17 EDT 2020 | inspiredmorris20
thank you both, We removed the connections and cleaned them. unfortunately no success, we are testing the conveyor interface board to see if we have a bad board. additionally we found that power supply #3 and #4 do have 110v going in but do not have
Electronics Forum | Mon Aug 31 07:06:20 EDT 2020 | bukas
did you try to unslot all computer boards (both PC and machine)and put them back? sometimes they loose contact and make wacky errors...
Electronics Forum | Tue Dec 29 17:42:27 EST 1998 | Dave F
| Can anyone recommend a solder stop that can be applied by our PCB supplier. Our current material form Tamura Kaken is causing problems. | | The material should be capable of withstanding 1 Surface mount IR reflow cycle and 1 wave solder cycle. | W
Electronics Forum | Tue Sep 01 11:53:21 EDT 2020 | inspiredmorris20
bukas, Yes, as soon as the software loads it immediately throws a 0002 (front E-stop pressed) and will not come out of EMER mode until i stop, reset, ready, on the control panel. yesterday however it also threw a E100 I/O I/F board communication d
Electronics Forum | Wed Dec 23 03:33:14 EST 1998 | Charles Stringer
Can anyone recommend a solder stop that can be applied by our PCB supplier. Our current material form Tamura Kaken is causing problems. The material should be capable of withstanding 1 Surface mount IR reflow cycle and 1 wave solder cycle. We need t
Electronics Forum | Fri Aug 28 17:47:59 EDT 2020 | inspiredmorris20
thanks Stephen!! I'm testing for voltage and have found 24v going through the E-stop to the main switch. If i trip the E-stop i can disengage the main switch. I have no more control to the hardware then that. The software is not throwing any code ot
Electronics Forum | Sat Oct 06 08:32:09 EDT 2001 | davef
Mr. Wizard is not currently available. You get the wizzer. Maybe your dream date will show later. Get your own lab tests done. Show your potential customer that your boards are clean. That�s the issue. The issue is not how you go about cleaning
