Electronics Forum | Fri Sep 22 14:07:29 EDT 2006 | realchunks
I think Sr is right. Miss prints are prolly a result of your tooling moving the board after the camera looks at the fids. It also could be the camera itself hitting the board from warpped board or tooling raising the board up. It may be the camera
Electronics Forum | Fri Oct 09 06:53:10 EDT 2009 | taus
Hello, I've recently started to work with MPM AP25, I began doing maintenance to get to know the machine. But now I'm having some problems in the teaching process. You can see the problem in the photo. http://img59.imageshack.us/i/image194p.jpg/
Electronics Forum | Tue Oct 13 01:39:37 EDT 2009 | jjmag921612000
If you are using a current board program, and then modifying to your new board. It is possible to have the wrong PCB dimension data in for your new PCB. You should review all of you basic information about the pcb, and then go into the fiducial teac
Electronics Forum | Mon Sep 25 09:18:38 EDT 2006 | daxman
Thanks for the posts guys, I'd like to mention a few things... In my opinion, the tooling does not get any better than this. The board is fairly small and quite stiff. There is no board warping. The tooling plates are tight and the vacuum really h
Electronics Forum | Fri Aug 18 09:29:20 EDT 2006 | chrisgriffin
I would measure the voltage on the yellow wire going to the air pressure sensor. Are you getting 24VDC? If so, maybe replace the input DC module on IO card #2. I think it is IDC module 8 on that board. Try not to have too many violent thoughts.
Electronics Forum | Mon Oct 31 14:46:54 EST 2005 | valuems
Hello Did you just buy this machine on the used market? There is a possibility that the stencil is not height on all 4 corners ( from the center nest assembly. I don't under stand " the under stencil wiper is not working correctly". This is about
Electronics Forum | Fri Apr 21 00:56:44 EDT 2006 | pavel_murtishev
Good morning, MPM AP25 we have is equipped with dedicated vacuum support only, no side snuggers. Also we had a lot of issues with fine pitch paste deposition due to this poor support. Vacuum support can�t fix wrapped boards properly causing a lot of
Electronics Forum | Fri Sep 17 15:43:08 EDT 1999 | Dave F
| HI everyone, | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 and .001
Electronics Forum | Fri Sep 17 21:25:00 EDT 1999 | Rob
| | HI everyone, | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 an
Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th
