Electronics Forum | Thu Jun 05 17:04:19 EDT 2003 | stepheno
The most important thing to remember when measuring tact time for a machine is to pick a point in the cycle and start measureing from that point untill the next board reachs that point. What is best is to measure multiple consecutive cylcles, that
Electronics Forum | Thu Apr 20 14:37:29 EDT 2006 | Chunks
The newer MPMs use the camera to find the board edge - no mechanical stops like AP and DEKs.
Electronics Forum | Tue Sep 16 14:57:59 EDT 2014 | emeto
Board stopX and Y. Have you tried to run the board on 180 degreese? Or 90?
Electronics Forum | Mon Oct 05 17:07:31 EDT 2020 | dekhead
Older machine models (Horizon / Infinity) allowed you to offset the board stop (thru crative programming) to run the larger board with parameters for the smaller board. That feature is eliminated with the Micron series. However, if you can get remote
Electronics Forum | Thu Mar 30 13:27:53 EST 2006 | bvdb
Just before Christmas we bought a used Fuji IP1 cheap. It took us a while but it's been working great for about a month. Yesterday the IP1 stopped after completing a board but before exiting the board out the conveyer. No error message, no alarm be
Electronics Forum | Thu Apr 20 14:33:18 EDT 2006 | dirk29
We had that problem with our printers we just drill and tap the top end of the stop and put a short screw in to allow us to adjust the top height of the stop and catch the board. Be careful not to make it to long or to could restrict the board from l
Electronics Forum | Mon Jul 17 07:26:59 EDT 2006 | aj
Guys, I have an annoying problem on the above mentioned machine. Basically, when the machine loads a board it sits and waits at the down stop until it times out. All sensors on the rail system work fine in the IO's, aswell as the board stop sensor
Electronics Forum | Tue Sep 16 15:54:39 EDT 2014 | gascon5383
I have not tried running it 180 or 90 degrees out. The process involved to change that would be too large for my company to accept it. I see where you can adjust the board stop x and y but is there a way for the z axis? I have found that the board is
Electronics Forum | Fri May 03 14:52:32 EDT 2019 | rusar
Hi, we bought the old UP2000 (2005 year) and are trying to teach him a new board. But at step 4 (Board stop X-axis) we get an error "Board stop sensor not made". Can anyone help and say what is the cause of the error? BR, Ruslan.
Electronics Forum | Fri Jun 03 20:21:56 EDT 2016 | sonavc
Thanks , I fix this problem. Now I know the boards stop near by camera.
