Electronics Forum | Mon Oct 05 17:07:31 EDT 2020 | dekhead
Older machine models (Horizon / Infinity) allowed you to offset the board stop (thru crative programming) to run the larger board with parameters for the smaller board. That feature is eliminated with the Micron series. However, if you can get remote
Electronics Forum | Sat Jan 21 10:28:16 EST 2023 | compit
The so-called "drivers" are used to control each servo - control boards at the back of the machine. There are several (8?). If one is "worn out" and has no strength to move the servo, maybe this is where the error comes from? They can be interchanged
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Wed Jul 19 07:27:09 EDT 2023 | roachindignant
This problem appears whenever I turn on my UP2000 HiE printer and try to perform the initial Reset. Hardware Limit Warning (E00938:10) All sensors on the Input/Output Screen are functioning appropriately and will give expected results when checked
Electronics Forum | Tue Nov 01 09:36:41 EDT 2011 | emeto
THe question is - does that happen on all of your programs or just in one program? If it is just this particular board, it might be some softwaRE limit issue. If it happens on more programs it is a hardware issue and it could be one of the following:
Electronics Forum | Thu Feb 21 08:20:43 EST 2013 | cowens
Thank you so much. We actually did get the machine up and running yesterday morning. We switched the theta and the transport driver cards and it is working now. We have had the connectors burn on us in the past and replaced them. I am hoping the prob
Electronics Forum | Fri Jul 29 02:50:18 EDT 2016 | pavel_murtishev
Hello, Could you please tell me what the latest Siemens F5HM software version is? Installed version we have is 407.03. It seems this software version does not support placement force adjustment for pick&place head that might be a critical point for
Electronics Forum | Fri Oct 02 13:55:58 EDT 2020 | lesfarnacer
hi , need help please with my DEK Horizon 03i , we trying to programme a longboard 600mm on the printer and board lengh on our printer is limited to 510mm . I checked on the hardware eve thing is ok but in the software we don't have the longboard op
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
.gif)
