Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
Electronics Forum | Thu Dec 16 20:41:56 EST 1999 | TNT
Hey C.K, If you are looking for inspection of the solder paste before reflow, there are many types of inspection: 1.Paste height measurements at random positions 2.3D inspection with shadow contrast capabilities based on an autocad format 3.3D inspec
Electronics Forum | Wed Feb 20 15:21:56 EST 2013 | rmitchell
Hi, hopefully I am too late, it is fixed and you are up and running. Have you tried MPM support on the phone? We have 2 older MPM's and the blow the driver modules in the bottom drawer on the back of the machine. There are different drivers for dif
Electronics Forum | Sat Mar 10 08:05:09 EST 2007 | davef
Here's your test definitions [clipped from the dictionary in the fine SMTnet Library]: * Test, Automated. Computer controlled electrical testing of parts, assemblies, or finished products. * Test, Built-In (BIT). An electrical testing technique whi
Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
Electronics Forum | Tue Jan 10 16:01:20 EST 2017 | davef
A review document for J-STD-001F with Amendment 1 had the following wording, but you should check the actual document to be sure of correctness 4.2 Facilities Cleanliness and ambient environments in all work areas shall [D1D2D3] be maintained at le
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -
Electronics Forum | Tue Jun 11 15:56:43 EDT 2002 | mjabure
Actually F4G is a programming environment similar to panatools, not a machine, it stands for "Fuji 4th Generation". The connection being questioned is to the communication network, and yes with the proper hardware you should be able to connect more t
Electronics Forum | Tue Nov 29 08:32:08 EST 2005 | stefwitt
Particular as a small company and limited resources you�ll be requiring a lot of assistance from the machine vendor. Did you check which other machines are used in your area and if there is already a local service tech? Did you get in contact with o
.gif)
