Electronics Forum | Wed Aug 28 10:16:12 EDT 2002 | Jim M.
Sam We install a lot of die in the SMT room using same process as SMT parts.Water soluble solder paste is used for attachment of die to ceramic and boards. Biggest problem i found is the adjustment from installing the die in the bonding area. The t
Electronics Forum | Thu Oct 11 13:37:35 EDT 2001 | Stefan
The pressure sensitive tape is used as an alternative to heat sealed cover tape. It works usually quite well and is easily applied by the taping machine, but it can create some problems in the tape feeder. In the Surftape, Cal is referring to, the c
Electronics Forum | Mon Jan 23 21:56:50 EST 2017 | jgo
Hi all, Am new to the SMT process. I'm in the process of purchasing a new SMT Pick & Place machine and am trying to figure out how to perform the buy-off. I'm from the semiconductor packaging background. For any new machine purchase, I'm used to se
Electronics Forum | Tue Jan 09 22:04:48 EST 2007 | Guest
Set Up Guy, I am not sure if the COB you are refering to means Circuit on Board . If yes, this process also include SMT . Package is a combination of some passive components and bare die. Passives are normally attached thru SMT using solder te
Electronics Forum | Thu Jun 06 08:16:13 EDT 2002 | caldon
Jim- Sorry I can not offer advice on the Panasonic machine but do want to shed light on the Die and waffle pack issue. Take note that if the Die are loose in the pockets the balls or terminations could be damaged. The thin layer that the ball is atta
Electronics Forum | Wed Mar 29 18:17:16 EST 2000 | David
Does anybody out there have experience building electronics assemblies with DCA (Direct Chip Attach - bare die onto PCB) and wire bonding? - What Die Bonder/Dispensing Machines are recommended? - What brand conductive epoxy were used to attach die?
Electronics Forum | Sat Jun 15 22:39:05 EDT 2002 | edahi
well we can't paste the flip chip on its substrate because we are using flux...because this bare die yet...and the surface of the die flipped might be contaminated...also after chip attach and reflow the die is to be underfilled and if the die is pas
Electronics Forum | Tue Jul 18 16:49:49 EDT 2023 | mahasg
Hello All, I am PhD student at polytechnique Montreal. We have a CQFP44 packages and Dies of 51um pad pitch (22nm FDSOI tech) that I need to bond myself at the university using ASM Eagle Xtreme gold wire bonder in the university. we need to perform b
Electronics Forum | Thu Sep 19 02:45:33 EDT 2002 | bugsjoe
Thank you ur reply Dave. Let me explain our COB workflow: 1. unpack PCB (FR4,LPI,HASL)(the thickness of gold and nickel we can't be find)(No SMT before) 2. clean the pcb by rubber 3. blow the pcb by di-ionic gun 4. attach die by adhesive gel 5. cure
Electronics Forum | Fri Nov 27 02:09:50 EST 1998 | Chi-Ting Chen
| | I have some 1.25 mils Al wire bonding chip on board process. After epxoy-based encapsulation, I do some aging test. How can I "see" or prove that there is a "wire break" exist due to the tension of thermal cycling? How can I know the failure is c
