Electronics Forum | Fri Jul 17 07:45:28 EDT 2020 | spoiltforchoice
Electronic feeders are faster, more accurate & fully programmable. Potentially (although they don't always make it possible) they mean you don't need dedicated feeders for 2mm pitch or at the other end can do 4,8,12&16mm using the same unit. The feed
Electronics Forum | Mon Dec 11 19:28:51 EST 2017 | spoiltforchoice
That's not really the point of dual lane feeders. As a general rule having a dual lane 8mm feeder means the machines "slots" are actually 16mm, dual lanes on a 8mm feeder helps keep the overall lane density of a machine higher, its much easier to bui
Electronics Forum | Tue Jul 07 11:00:49 EDT 2020 | kierantennant
hi, I was wondering if there was a way to calibrate the ASM smart X feeders?
Electronics Forum | Mon Oct 21 03:27:15 EDT 2019 | btkhoo68
we would like to monitor ASM siplace feeder, cycle time, nozzle.event using SCADA. Anybody able to provide memory address allocation for above data value to read by SCADA
Electronics Forum | Tue Jul 14 10:04:51 EDT 2020 | kierantennant
Has anyone got any experience of the ASM X Feeder Verification system? as you can no longer rent the product I am struggling to justify the cost and was wondering if anyone has experience with the benefits this machine provides and if the cost is jus
Electronics Forum | Tue Jul 07 13:26:37 EDT 2020 | emeto
Yest you can. You need the calibration station, that you can buy or loan from ASM.
Electronics Forum | Tue Jul 07 13:40:02 EDT 2020 | kierantennant
I have seen this calibration station. however do not understand how the next stage of calibration work. does the device calibrate the feeder itself or is it a manual process? IF so what is the process to get the feeder calibration correct?
Electronics Forum | Tue Jul 14 20:03:33 EDT 2020 | emeto
I think the price is around 20k per feeder. One feeder is good for one machine and one side(in case of dual head system. We couldn't justify the cost based on the related rework we have.
Electronics Forum | Tue Jul 07 14:01:26 EDT 2020 | emeto
I don't remember details as it's been a while. They will train you how to do it. It was worth it - I think we loaned it for a week or two and recalibrated all feeders we had for 3 lines.
Electronics Forum | Tue Jan 28 15:25:07 EST 2020 | emeto
If you refer to having wrong resistor or capacitor value, the only way is to automatically measure the part value. Mycronic pick and Place machines do it on the fly, ASM machines have feeder where part is measured....other main brands probably have
.gif)
