Electronics Forum | Tue Jun 23 22:14:16 EDT 2020 | kumarb
Hi. Guessing that you are operational by now? If not, consider to use BGA definition and use the editor to define where the bottom side pads are or are not. Just our 2 bits input. The Assembleon X / Yamaha units are quite flexible - using an electron
Electronics Forum | Wed Jun 24 10:17:50 EDT 2020 | kylehunter
> Hi. Guessing that you are operational by now? If > not, consider to use BGA definition and use the > editor to define where the bottom side pads are > or are not. Just our 2 bits input. The Assembleon > X / Yamaha units are quite
Electronics Forum | Wed Jun 24 14:42:03 EDT 2020 | kumarb
Hi. Heck no! First, you should find out the Yamaha equivalent of your machine, if known - that is a more common reference when sourcing parts. While we have no affiliation with the vendor other than a very positive history of sourcing a laundry list
Electronics Forum | Wed Jun 24 15:46:26 EDT 2020 | kumarb
The blue handle CL feeders are 4mm advancement pocket to pocket - suitable for 0402 devices. The green handle CL feedersare 2mm advancement pocket to pocket - suitable for 0201 / 01005 devices. According to Elissa, she did not recommend the use of
Electronics Forum | Wed Jun 24 16:05:23 EDT 2020 | kumarb
Posting a few more pix on how the 24V is sourced from our Emerald-X (Yamaha YV88X) which looks very similar to your machine. Look for the power supply connector for the dump feeder (which we bought used out of Shenzhen - working well). The green belt
Electronics Forum | Thu May 20 22:38:01 EDT 2021 | kumarb
For closure to all readers of this thread...many thanks to Michal for this support. Trans-tec (USA) was great in replying to our countless emails on this topic. We sourced a replacement solenoid # A041E1-48W for our Emerald-X = YV88X. The part was a
Electronics Forum | Mon May 17 10:59:02 EDT 2021 | kumarb
Hi. Have an Emerald-X machine with FNC purchased refurb from Assembleon with mixed results at 3500 hours. Had it sitting idle for years due to assorted issues after their installation. Only now after much time and parts investment have the machinery
Electronics Forum | Tue May 18 09:58:17 EDT 2021 | kumarb
Thank you so much for the advice. We were suspecting blockage but know that we have clean nozzles. Did the air blow out and removed a spot of black matter - perhaps what was an old o-ring? Nozzles are 61 and 62 posing the issue. Our tech said that 64
Electronics Forum | Tue Apr 10 02:57:53 EDT 2018 | rob
Yes I would, most of our old Yamaha machines (before 2005) will do 30-35 microns @ 3 sigma with the fine camera option. Our Jukis with His res camera's will hit it too. You should be OK with most things after 1997 with the right camera choice (whic
Electronics Forum | Wed May 19 20:11:21 EDT 2021 | compit
I have two machines - Emerald-X and Topaz-X. I cleaned (and changed Koganei electromagnets) only in Topaz-X - Emerald-X is in very good condition :) But my Emerald-X have SF (not FNC) heads. If head 1 is OK - change the relays with head 2 and check.
