Electronics Forum | caldon |
Wed Jun 04 13:19:57 EDT 2003
Electronics Forum | Thu Sep 19 16:58:45 EDT 2019 | kylehunter
So.. I thought I had fixed the issue, but it seems not. The issue that was causing the fiducials to not be found, I 100% have solved. The board was not reaching the stopper before being clamped, causing the board to be a few mm's offset. I added a de
Electronics Forum | Thu Sep 13 13:29:06 EDT 2001 | mparker
Dave et al, I just print out and read a copy of the aforementioned recommended article. Mr. Mangin gives a clear picture of why DPMO is to be considered a more pure data than First Pass Yield (FPY). However, I must note that his interpretation of h
Electronics Forum | Fri Mar 15 17:00:56 EST 2002 | stefwitt
Steve, let me add a more lengthy note on the current service situation, which does not apply for Assembleon alone. I think it was April last year when Nokia re-adjusted their growth rate from 40 % to 10 %. Followed by Motorola�s massive lay off and p
Electronics Forum | Tue May 23 21:14:22 EDT 2006 | davef
First, where the temperatures that aare mentioned in the original post measured? Second, it sounds like the PdAg component terminations are not seeing enough heat [your soldering iron touch-up proves this]. Your 232*C peak is the absolute minimum s
Electronics Forum | Mon Aug 20 08:16:10 EDT 2001 | Stefan W.
Hi Dave, for several reasons the machine computer(s) should be connected to the LAN. 1. The machine computer can be as old as a 486 with a couple of hundred Mb hard drive and the more programs you store in there, the slower it gets. 2. If you put al
Electronics Forum | Thu Jan 17 18:29:01 EST 2002 | Bill Loving
Dear Jason, Thank you for posting your request on SMTNET. Please note that ScanCAD International provides an upgrade path for all installed customers, regardless of the age of their system. Currently, hundreds of systems are installed in 37 countr
Electronics Forum | Thu Jan 17 18:33:24 EST 2002 | Bill Loving
Dear Jason, Thank you for posting your request on SMTNET. Please note that ScanCAD International provides an upgrade path for all installed customers, regardless of the age of their system. Currently, hundreds of systems are installed in 37 countr
Electronics Forum | Thu Jul 13 22:20:38 EDT 2000 | Dave F
=10 mils larger than lead 3 silk screen legend text weight >=10 mils 4 pads >=15 mils larger than finished hole sizes 5 place through hole components on 50 mil grid 6 no silk screen legend text over vias (if vias not solder masked) or holes 7 so
Electronics Forum | Tue Jun 17 10:46:16 EDT 2014 | bestglobalsmt
When the machine loads up it gets to the 2nd to last step where it starts to load vacuum data - we get 4 pop up windows once that fails. Ea2510 Machine Start error - Machine cannot be started Es00212 APPL CPU Haandshake error Ea2504 I/O Data trans