Electronics Forum | Tue Dec 18 22:21:09 EST 2001 | davef
What does Kardex Systems [ http://www.kardex.co.uk/ ] say? Won't they sell you an operating manual? Won't they provide site support? The shuttle seems to be a current product. Look under "Divisions & Products" and "Material Handling Division" on t
Electronics Forum | Tue Oct 20 17:30:15 EDT 2009 | rodrigo
Hi all, We use the IMF converter (and a floppy disk) to move programs to and from the MCS30. The only way to get to the command line in the MCS30 is to reboot and do the ctrl+shift+_ ketpresses. I wanted to try to add an entry to the Fuji User inter
Electronics Forum | Wed Dec 11 09:36:18 EST 2024 | introlab
In the main menu, press the SW version icon, then type ilovesafety and the top blue line will start blinking, select the close button. Press the software setting icon, now you can use the operator setting icon to change /recover password.
Electronics Forum | Tue Jun 23 22:14:16 EDT 2020 | kumarb
Hi. Guessing that you are operational by now? If not, consider to use BGA definition and use the editor to define where the bottom side pads are or are not. Just our 2 bits input. The Assembleon X / Yamaha units are quite flexible - using an electron
Electronics Forum | Wed Jun 24 10:17:50 EDT 2020 | kylehunter
> Hi. Guessing that you are operational by now? If > not, consider to use BGA definition and use the > editor to define where the bottom side pads are > or are not. Just our 2 bits input. The Assembleon > X / Yamaha units are quite
Electronics Forum | Thu Feb 16 09:37:11 EST 2006 | mgillespie
hi, > > we tried to introduce form-flex a few > years back and it caused more problems than it > fixed. > > Switched back to pins and no > problems. > > It might have improved since but I > would be reluctant to get them again unless I was >
Electronics Forum | Tue Feb 28 12:34:12 EST 2006 | pr
Gel flex is crap! If you put enough in to actually support the board, it bows. Apparently MPM knows this because they include hard pins with the set (kinda defeats the purpose huh)! I trialed the grid-lok and it worked fine and operators loved it. Th
Electronics Forum | Tue Feb 28 11:07:41 EST 2006 | Chunks
Gel Flex works for Dek, just a slight modificaion. Works 100% better than any Grid type of system. We had missprints from Grid Lok and Form Flex - about every 5th or 6th board. Until we modified the Gels, we would take the time and some peelable s
Electronics Forum | Tue Feb 28 16:45:23 EST 2006 | charlie
Why don't you try it for yourself. It won't cost you anything in most cases. Anyone with a negative impression about the product may want to contact Grid-lok (support@grid-lok.com or sales@grid-lok.com) for applications or tech support to be sure th
Electronics Forum | Wed May 17 16:01:48 EDT 2000 | Janet Tietz
I work for a small assembly company that is starting to branch into SMT. I have been choosen to run the setup since I have the most computer skills and greatest knowledge of componets in the shop. However, I am finding out I need a lot more knowled
