Electronics Forum | Fri Dec 15 11:01:14 EST 2017 | robertorocco
I have one Topaz X FNC machine with this problem. The head 2 FNC not change the nozzle. The head 4-6-8 is ok and change, but head 2 no, when he tries to change the nozzle he gives me an error message. What could be the problem?
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Wed Feb 13 16:27:28 EST 2019 | aldrich17
R axis is the rotation of the heads. 180 degrees and -180. The sensors tell the machine when the heads are switched correctly on the flying nozzles and the correct rotation. also i think they involve the clutch as well. After i make an adjustment to
Electronics Forum | Fri May 10 01:42:13 EDT 2019 | vinitverma
A Table is something that you can ignore right now. It is significant only in case of dual table machines such as Sapphire or Sapphire-X which have A and B tables (two independent PCBs being handled at the same time). In case of Topaz or Topaz X or E
Electronics Forum | Sat Oct 06 15:00:42 EDT 2012 | chrisnims
We bought a used 1999 topaz x and are trying to get it up and running. unfortunately we are getting an error: Anyone know where i can get a service manual or having any idea where to look to resolve this problem? "E229" “Nozzle down limit sensor is
Electronics Forum | Thu Nov 24 01:45:44 EST 2005 | pavel_murtishev
Good morning, My advice is to put two Topaz-Xii in line. Machine programming is rather easy (with PPS and GPP that AssemleOn offers), but final teaching on machine is strongly required. If you want to prepare programs fully offline you�ll have to pu
Electronics Forum | Tue May 05 14:57:48 EDT 2020 | greezmky
I will have to check the nozzles to see if they are stuck up, but I don't believe so as I changed them all out a couple weeks ago. I have not went back to the feeder yet because I am not getting vision errors. I was able to see the diodes fly off on
Electronics Forum | Thu Mar 08 03:13:20 EST 2018 | rob
Don't go down that route, Juki cut spares support a few years ago on these. Although bits are available from China, you do not want to be swapping used cards. They are both also dog slow in real life whatever you do to them. Especially a 760. We'r
Electronics Forum | Sat Dec 17 15:46:28 EST 2005 | Csabee
Samsung SM320 don't have sensor for recognizing component. Only using Fly&Fix camera. In first time the korean samsung service engineer advised me (3,7light settings for chips and the machine generated many dumps, sometimes 50 or more per day. But n
| 1 |
