Electronics Forum | Wed Jun 16 14:07:15 EDT 2021 | oxygensmd
For example, I had the same problem on my Rehm oven. It was in calibration mode. The machine is going to maximum transport width but sensor wasn't reached and the machine stucked in calibration mode. Maybe there are manual mode for transport width a
Electronics Forum | Mon May 18 14:46:38 EDT 2020 | dnachristen
Hello, We are looking for sources to keep our old Comtra Belt Feeders going for our Assembleon equipment. Mainly the belts that transport the component forward. Comtra went out of business years ago and parts are no longer available. I'm just looki
Electronics Forum | Tue Sep 27 17:23:57 EDT 2011 | ck_the_flip
We use Assembleon FT-series feeders.
Electronics Forum | Tue Feb 24 16:57:03 EST 1998 | henry
EQUIPMENT FOR SALE QUAD 100 V3/V6 Low hours, Excellent condition, All latest factory revisions Firmware 3.65 Central controller software 5.6D with computer system Autoprogram software 5.31 1- 28" Latching feeder base 5- 4" Latching feeder b
Electronics Forum | Mon Mar 18 09:19:48 EDT 2013 | marcelorotofrance
I can move the axes XYUV just in short steps through the "MANUAL NC" function. The axis encoders seem to work; the readings of position follow the axis movements. However the actual position of the head has nothing to do with the readings at the disp
Electronics Forum | Thu Jan 02 04:56:38 EST 2014 | bobpan
Here is a couple of things to look at: 1. Make sure the boards are plugged into the correct position. Also just leave out the transport card to see if its hanging up the machine. The transport board should be the board all the way to the right. 2. M
Electronics Forum | Thu Aug 09 15:16:20 EDT 2001 | Adam
Thank you Michael, yes we use a Fine Focus X-Ray machine, we also had some dummy connectors to play with, so we profiled the board until we reached a desirable profile. For placement we used a GSM machine, the only issue we ran into there is the par
Electronics Forum | Thu Aug 09 15:16:31 EDT 2001 | Adam
Thank you Michael, yes we use a Fine Focus X-Ray machine, we also had some dummy connectors to play with, so we profiled the board until we reached a desirable profile. For placement we used a GSM machine, the only issue we ran into there is the par
Electronics Forum | Thu Dec 08 11:50:40 EST 2005 | Stefan
If you mention mis-alignment and missing component in the same sentance, I suspect the component is not properly released after placement. Assuming the Juki machines use an air blow, after vacuum shut off, than I would look at a correct air flow firs
Electronics Forum | Fri Mar 15 20:56:55 EDT 2013 | marcelorotofrance
At this point all the sensors, switches and solenoid valves were checked. Their electrical signals and actions were phisically checked at the I/O cards level (Panadac 783-065 and 065A). Above mentioned signals were monitored from "I/O Monitor" functi
