Electronics Forum | Wed Sep 22 08:26:53 EDT 1999 | g cronin
i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the screen/ass
Electronics Forum | Thu Sep 23 22:31:25 EDT 1999 | Dave F
| | i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the scree
Electronics Forum | Wed Sep 22 09:25:42 EDT 1999 | Wolfgang Busko
| | i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the scree
Electronics Forum | Wed Sep 22 10:03:07 EDT 1999 | Boca
| | | | i'm sure everyone has run into this at one point or another. I have a thin pcb .025 that is single up that has to be built on a pallet. does anyone have any tricks to the pallet design that will help to hold these boards down during the s
Electronics Forum | Tue Aug 11 07:49:42 EDT 2020 | kasun_elk
During the movement of the placemat head, components drop on the PCB. Sometimes machine doesn't give error massage for drop component. How to manage additional components detection in 2D AOI?
Electronics Forum | Thu Nov 10 13:55:25 EST 2005 | 1st Article
Milroy, Another thing to look at is your wave profile. Check speed and pre-heat, if flux gets burned off before reaching the wave then bridging is expected, a common way to check for speed is to time the point of first contact through the sub-merge
Electronics Forum | Fri Nov 09 04:15:25 EST 2007 | reypal
how about applying solder resist on the area where you have bridging occurs..you may ask your pcb supplier the possibility.
Electronics Forum | Mon Nov 05 00:51:58 EST 2007 | omidjuve
We have a problem with soldering of a 96 pin header connector(9001-11961c00l1a from kingmate) we use 3 different wave soldering but in all of the machines we have many short circuit between the pins . the wave soldering machines that we use is fr
Electronics Forum | Thu Sep 23 17:31:12 EDT 1999 | DaveH
For another excellent vendor try EMC GlobalTechnologies in Pennsylvania (215)340-0650. Contact Marty Wetzel. | | | | | | any thoughs? | | | | | | thanks | | | | | | | | You should use pallets that stand the reflow as well so that no separation wi
Electronics Forum | Mon Jan 21 12:43:13 EST 2013 | emeto
A good fixture is the key here. The first side should be easier than te second(if double sided). In both cases I will try to level the top of the board with the top of the fixture. Try to lock with pins comming from the fixture to the PCB holes. This
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
