Electronics Forum | Tue Mar 30 05:55:52 EST 2004 | Repair Process Tech
When we need to apply paste during BGA rework we normally order a stencil from our stencil vendor. In most cases all we need to do is tell them the assembly and location plus quantity and they do the rest for us. Usually we'll have several types of a
Electronics Forum | Fri Nov 21 16:48:05 EST 2008 | kennyg
Anyone have an 'easy' solution for reducing PCBA handling damage. I'm fighting low level chipped, scuffed and broken-off SMT parts. The damage is spread out across different areas of the assemblies. The assemblies are double sided SMT with 0402's
Electronics Forum | Fri Jun 11 04:38:05 EDT 1999 | Gyver
| | | | | Hello all! | | | | | Recently we got a problem about the Funtional test. Some boards passed tests by using the auto-fixture(vacuum), but failed by using manual test fixture(need to plug CPU, DIMM etc.). The error symptom is no picture. We d
Electronics Forum | Mon Jun 14 09:16:58 EDT 1999 | Adam Pratt
| | | | | Hello all! | | | | | Recently we got a problem about the Funtional test. Some boards passed tests by using the auto-fixture(vacuum), but failed by using manual test fixture(need to plug CPU, DIMM etc.). The error symptom is no picture. We d
Electronics Forum | Fri Feb 13 08:54:43 EST 1998 | justin medernach
| Hi , | I have not been able to find any good description on how to perform double sided reflow on PCBs.The best would of course be to avoid reflowing the bottom side again but in real life this is not possible. | So when double sided reflow sol
Electronics Forum | Wed May 19 14:58:31 EDT 1999 | Wendy Casker
John, Thanks for the advice. I spoke with some of the connector suppliers apps guys today and they have what is called "European" style tooling which consists of top and bottom tooling. The board sits on rails and the Bottom tooling receives the pi
Electronics Forum | Fri May 21 15:51:49 EDT 1999 | JohnW
Wendy.. I found that little nugget a good one from my connector suppliers..Oh we have a tool to put it in for u..only catch was the one I needed was �37K ! ! after falling off my seat I went for something like what I described blow..cost about �1K.
Electronics Forum | Wed Apr 15 14:57:20 EDT 1998 | D. Lange
| | | | We are having a bridging problem with SOIC 14,16 and 20 pin devices during flow solder of the bottom side of our boards. This bridging occurs about half way up the lead between the board and the body of the IC. The chip parts are no proble
Electronics Forum | Wed Apr 15 14:53:06 EDT 1998 | D. Lange
| | | | We are having a bridging problem with SOIC 14,16 and 20 pin devices during flow solder of the bottom side of our boards. This bridging occurs about half way up the lead between the board and the body of the IC. The chip parts are no proble
Electronics Forum | Mon Jun 18 01:09:03 EDT 2001 | Dean Stadem
Igmar, If these parts are epoxied in place, and subsequently wave soldered, I would bet you a cup of coffee that they are cracking due to the thermal shock of the wave. Typically there is a valley or dip in the temperature after the pre-heat in the w
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
.png)
