Electronics Forum | Wed Aug 25 14:34:38 EDT 1999 | Tony
| Can anyone tell me where I can get a good lightweight material to use for a soldering fixture? I need to make various fixtures to hold LED's vertical during the soldering process, and keep them from floating up off the board surface. | | At a dif
Electronics Forum | Tue Apr 07 10:01:04 EDT 1998 | Steve A
| Good Morning everyone. Per repeated suggestions I have been reading back issues of SMT and Circuits Assembly magazines. I have just read an article concerning selective wave soldering which I understand is to be used when active SMTcomponents are
Electronics Forum | Tue Jan 12 17:46:26 EST 1999 | Tom Gervascio
| | Good Morning everyone. Per repeated suggestions I have been reading back issues of SMT and Circuits Assembly magazines. I have just read an article concerning selective wave soldering which I understand is to be used when active SMTcomponents a
Electronics Forum | Wed Aug 17 13:57:27 EDT 2005 | ppwlee
We have encountered what appears to be mask discoloration after wave soldering. The areas of concern coincide with the areas that were exposed selectively by fixtures during wave soldering, dominated by one date code of PCB with a slightly different
Electronics Forum | Fri Jun 04 14:00:32 EDT 1999 | Arthur Burdick
Wendy, we at ASG make electric presses for press fit connectors, and have made fixtures for AMP Zpak connectors. give me a call i believe we can help. 561-848-6746 Arthur | Wendy.. | | I found that little nugget a good one from my connector supp
Electronics Forum | Wed Nov 01 08:17:39 EST 2000 | Adam
we have a variety of products which we build and manufacture and build on our site, 90% of which go over the wave solder. What I would like to know is when designing a WSC how do I know what the correct angle of the aperture is in relation to the wav
Electronics Forum | Sat Mar 20 00:29:07 EST 1999 | Vinesh Gandhi
| | Hi Folks, | | This is my first surface mount board, so I asked our assembly house for some tips. They said only passives on the bottom side-preferably no smaller than 0805, 0603 only if I have to. I would think that an SOT-23 would be OK on the b
Electronics Forum | Sun Mar 21 06:27:45 EST 1999 | Bob Willis
| Hi Folks, | This is my first surface mount board, so I asked our assembly house for some tips. They said only passives on the bottom side-preferably no smaller than 0805, 0603 only if I have to. I would think that an SOT-23 would be OK on the botto
Electronics Forum | Wed Mar 24 19:26:25 EST 1999 | Marc Ruggiero
| Hi Folks, | This is my first surface mount board, so I asked our assembly house for some tips. They said only passives on the bottom side-preferably no smaller than 0805, 0603 only if I have to. I would think that an SOT-23 would be OK on the botto
Electronics Forum | Fri Jun 26 19:59:07 EDT 1998 | Scott McKee
| can any body help on assembling straddle mount connectors on to a board? for information on the connector - it is a berg micropak connector 1. You need a fixture to insure the pins don't bend while inserting them on the board, coplanarity is a re
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155