Electronics Forum | Tue May 10 15:57:43 EDT 2011 | jamike
Hi I am responsible for the whole of production and test and have been given the job by my manager to get accurate job times on all assemblies timing various staff. I have 18 years experience working in all areas of production and test so I know the
Electronics Forum | Wed Nov 07 17:09:07 EST 2001 | davef
We do this periodically. For each year of the analysis, we do a sheet like this � Capital [By Outsourcing, In-house] * Assembly * Testing * Total Working capital [By Outsourcing, In-house]
Electronics Forum | Fri Nov 09 20:33:28 EST 2001 | caldon
There is two directions I see here...1) you are looking for a bid comaprison or 2) you are going to build boards with the machines you cause they are not being used in full capasity. Some OEMs and/or CEMs charge extra for "cut tape" (Not full reel)c
Electronics Forum | Thu Apr 12 07:47:30 EDT 2007 | Bob R.
No job is worth lying and fraud.
Electronics Forum | Mon Mar 16 08:34:46 EDT 2009 | sachu_70
Hey Loco, how about saving the bottom side? It actually only depends on your oven setting specific to Top heaters and Bottom heaters. Unless you set the parameters rightly, you would face such issues. It only indicates that you need to seriously re-l
Electronics Forum | Fri Sep 16 10:01:40 EDT 2005 | Mark
Get a hold of a couple different contract manufacturers with some fake jobs. Than see how they map out their quoting and assembly process. I know we map out the whole overall cost and break it down for the customer. But for competitive reasons I can'
Electronics Forum | Tue Jul 18 11:32:40 EDT 2006 | Joris Groot koerkamp
I am wondering what skills operators need to run an smd line itself. At our company they know how the pick&place machine works (refill/ changover), but if there is a problem with wrong placed components they don't known what to do. Our managmenttea
Electronics Forum | Thu Aug 13 12:23:39 EDT 2009 | robhs
Thanks Dave. What you say makes complete sense. We ran a job a short while back in this way (though without bonding) and found we had a much higher than normal failure of the BGAs which I can only attribute to the secondary reflow. As I have only got
Electronics Forum | Tue Jul 18 16:40:09 EDT 2006 | dphilbrick
We have a system where when we set up the line to run a job before the first part is placed an auditor verifies we have all the correct parts loaded on the machines in thier correct locations. We then run a first article. The board is inspected to in
Electronics Forum | Sat Jul 06 19:49:41 EDT 2013 | sarason
My software can easily open a PCB CSV file so this is probably the easiest way for you to generate a file. The setups are remembered via a write to the registry, so you can go with a standard set of values to arrive at a very usable file without havi
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155